I use the next tool button after Tool length measure. It will go home and change tool. Saves some steps. Next tool only works if tool offset is used. Nice video. I will add to my lesson plan. I also dry run in air after graphics check. We use probe a lot and shift the G92 Z+2.0. To dry run. Same With manual blue block setup. Same thing. I teach both methods
Esto es una joya amigo ! Soy de latinoamericana y estoy muy interesado en aprender se Solidworks y estoy aprendiendo mastercam pero lamentablemente acá no tenemos mucha chance de agarrar experiencia me gustaría trabajar contigo se un nivel de inglés básico pero tengo muchas ganas de aprender
Instead of punching in -2.0 for every tool you can touch off all your tools then just put -2.0 in the z work offset. In a real world setting where time is money this is a more productive way.
I'm just learning the haas control but I don't think this is the right way to do it, you actually touch off your tools at the top of your stock for every job? Maybe that works but wouldn't it be better to set your tool height offsets once, from a fixed reference like the bed or home. Then just find your stock Z height from that reference and set in G54.