Sheet Metal Tutorial | Engine cover design in Creo Parametric 

Try to reduce the flange height and check

same issue

Try to modify the dimension of the flange

It's 30 degree one side and 120 degree other side. You can go with any angle depending upon your side.

@@CADxTraining ok

Sorry, problem is on me. The measures are inch not mm, i figure it later.

Try to increase the part accuracy.

@@CADxTraining the only difference I see is that, when I make the flange, i have to select one by one all the edges, while I saw that you do all in one time. Can be this the cause of failed regeneration? just in case, can u explain how do you select all edges in one time? thanks

@@mechlown right click the edge and then left click

need to long press of right click

​​@@adityakshirsagar6059good luck for your future

Try to increase the accuracy. Go to "File-prepare-model properties-accuracy" and increase the accuracy. Change the value to 0.0001 that's it.

@@CADxTraining THANKS IT WORKED

Increase the part accuracy

@@CADxTraining I made it 4 times Bro, but still I'll work on it.

Change the part accuracy

You can take a snapshot in hd resolution from the video.

Move the flange outside the edge.

@@CADxTraining still not unbend in this also it shows error Highlighted swept flange walls cannot be unbent. Recommended actions: Redefine flange wall section or trajectory.

Try to increase the accuracy. Go to "File-prepare-model properties-accuracy" and increase the accuracy. Change the value to 0.0001 that's it.

@@CADxTraining itS done thanks

Good to hear.

Increase the file accuracy. It will work. ru-vid.com/video/%D0%B2%D0%B8%D0%B4%D0%B5%D0%BE-h8cFpa67nFI.html

@@CADxTraining Thank you so much. Its worked. I tried multiple times but I failed. Thanks for this support & your video is very informative.

Play the video at 1080p

If you are getting any error then try to increase the file accuracy.

"Feature failed to regenerate" always show me this

Highlighted surface cannot be bent back. Highlighted swept flange walls cannot be bent back. This two messages also

Increase the file accuracy and try

I tried that too, but everything is the same again