Тёмный

SIMRAD Fuel Tank Setup 

Premier Marine Pontoons
Подписаться 1,3 тыс.
Просмотров 46 тыс.
50% 1

Опубликовано:

 

1 окт 2024

Поделиться:

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист
Посмотреть позже
Комментарии : 14   
@BurdenWorld_
@BurdenWorld_ 3 месяца назад
Bro, thank you so much. This is been irritating for me and I appreciate the hell out of you lol
@billbench9598
@billbench9598 2 года назад
If I need to re-calibrate with a full tank of gas. Can I remove the sending unit to simulate an empty tank of gas?
@SF-rl7hl
@SF-rl7hl 10 месяцев назад
There is no fuel app on left when I go into settings? I have Simrad NSX9. Help? I have Garmin GFS10 on NEMA 2000
@probman12
@probman12 Год назад
Nmea system on sinrad go 9 reads 78 gallons but there is approximately 32. Can not get it to read correctly. Maybe sensor trying to read from both vessel and nmea system? Worked find for a year and nmea went off. Finally got bus back on.
@justinhess8048
@justinhess8048 3 месяца назад
Can fuel levels be set with fuel in tank?previous owner did a reset to factory on sinrad,I believe there to be 3/4's of a tank.
@premiermarinepontoons
@premiermarinepontoons 3 месяца назад
Hi Justin, I am checking on this with our customer service and engineering team and will follow up with you. Thank you!
@premiermarinepontoons
@premiermarinepontoons 3 месяца назад
HI Justin, Our Customer Service team provided this response: Yes, it can be set up with fuel in the tank. However, they may need to fill it to the brim and go by the tank’s printed capacity on the manufacturer’s stamp if they are unsure of exactly how many gallons may be in there. If the provide a hull ID, I can find more information.
@marcooliveira5595
@marcooliveira5595 Год назад
Hi, how can i setup the fuel with the gás tank full…i did not calibrate with empty tank😢
@andrebandeiras7931
@andrebandeiras7931 3 года назад
Anyone instaled on nmea2000 network the liquid sensor for fluel tank KUS liquid sensor NS5? Each videos for Simrad needs to calibrate the sensor, but yesterday i instaled this sensor on my simrad evo3s and dont need . Acuse imediatly full tank. Thanks
@fastidolsportfishing3728
@fastidolsportfishing3728 3 года назад
Do you have to calibrate or do any steps every time you fill up the tank with fuel ?
@NickSavino
@NickSavino 4 года назад
We recently purchased a new boat but did not calibrate it when the tank was empty. We only did calibrated it once we filled up the tank to full. Now it only reads full and does not go down when we use it. Any idea as to why or what we need to do to fix it?
@1dotele
@1dotele 3 года назад
same with me these suck now you need to drain the tank to set it up? getting a Garmin
@tritoons
@tritoons 3 года назад
I've seen one that had a bad fuel tank sensor that converts the analog signal from the sender to the digital needed at the Simrad and it can cause this problem and need to be replaced. It's generally under the dash and connects to the NMEA network backbone. Your dealer can handle it. Garmin is great if you're looking for basics but the Simrad really is a lot better. I've used them all. Also, this generally works fine without the calibration. I would skip that part entirely.
@justinleland
@justinleland Год назад
Thank you!
Далее
Simrad Go Chart Plotter Setup
30:21
Просмотров 95 тыс.
Setting up a Simrad Digital Fuel Flow Sensor
8:28
Просмотров 2,9 тыс.
Как открыть багажник?
00:36
Просмотров 15 тыс.
SIMRAD Initial Setup
6:03
Просмотров 35 тыс.
Docking A SINGLE Engine Boat SIDEWAYS!
8:05
Просмотров 3,6 млн
Smart Meter Disaster!!
16:33
Просмотров 441 тыс.
Simrad NSS Evo2 | Monitor Fuel and Engine Data
4:29
Просмотров 115 тыс.
How Do You Make Rocket Fuels?
17:43
Просмотров 390 тыс.
SIMRAD Audio Setup and JL Media Master
7:27
Просмотров 11 тыс.