Thats good to know thanks for the insight, My EZM2 is at Sinn for a service so I may ask them for one and that way they can post it back with my watch , cheers
Thanks for the video. I like the look of the fine link. I don’t own a Sinn but I really like the look of the 356 copper dial chronograph. I think that watch would pair really well with the fine link bracelet. Not many authorised dealers of Sinn in the UK, would like to see it and try it on before buying.
@@nkonig1 The Sinn guys are normally pretty helpful and i'm sure if one is near by they will help you out I don't have 356 myself but I've seen it once and was impressed
I have a few Sinn myself 756 the old ice hardened case from 2002, 104 green dial , and a UX SDR EZM 2B. Looking to maybe grab another. The military type IV on nato might scratch the itch. Great video keep up the good work
Thank you very much for the sharing. I bought a U1 last year, and then earlier this year I got the limited 104 St Sa A B E, as it comes with two fabric straps, I am thinking to get a stainless bracelet to go with it, thinking about the H-link or the Fine link. (I might get a Fine link after watching your video). Or please share your thought which one would be better to go with it.
Great content, just bought a used UX Hydro GSG9, but it comes with a rubber band, like to know where can I find the original bracelet for this watch? Or maybe you have extra you like to sell? Thank you.
Thanks the UX is a very special watch I did a review of my one on my channel before , I don't have a bracelet for sale , I got my one from Sinn as I remember there not to expensive , I do have a 20mm Sinn brown leather strap and deployment clasp for sale but that's it Sir
I see Watchgecko now do a H link in both Matt and Matt with Polished centre links. Unfortunately no Sinn endlinks but at about £80 much cheaper than Sinn and buckle may be better.
I found the fine link had some hot spots. The pushers are sharp. Also the edge of the bracelet is kind of sharp. I'll have to use some ultra fine sandpaper to round it all off
Just picked up my first Sinn a 556i on H bracelet and I knew going in that the clasp was the weak point of the bracelet and it sure is. It’s a tinny oversized cheap looking clasp but the watch overall is killer so that outweighs the shitty clasp!
There isn't a titanium bracelet listed for the 104 but you maybe able to fit one from another model too but you'd have to keep the end links. You wouldn't have the same finish as the case , I prefer the feel of the steel over the titanium personally I have a titanium on my EZM1
Do you think it's possible to swap out the clasp of the H-link for a hidden fold over clasp - best of both worlds?! Any idea where you could buy a 3rd party clasp compatible with the h-link?
@@ClickSpringReview that would be amazing if you do. I've found your vid about swapping the H link for the fine link, but can't find one about swapping the clasp specifically
Ive check and it was only swapping the silicone strap over to a different clasp ru-vid.com/video/%D0%B2%D0%B8%D0%B4%D0%B5%D0%BE-AwwOl8cRZjc.html The H-Link is rivet in place so can't swapped with out a lot of work going in to it
Thanks Thomas I got hold of a new 104 blue on a newer fine link bracelet the other day so after I did the review I did a comparison video with my black dial 104 on a H-link and spent most of the time talking about the different bracelets, so I plan to release that in the next few weeks 👍🏻
@@ClickSpringReview I’m about to buy a 556a, I think I’m better off buying directly from Sinn, just not sure whether to go red / white seconds hand and h / fine link bracelet. Thanks for replying
@@ClickSpringReview yes I think you might be right, the more I think about it, I like the white seconds on the h link and the red seconds on the fine link. But I prefer a clean look too so most likely will opt for white seconds on h link. Again, thanks for replying, subscribed
I've just checked and yes it does fit Jorge but its a little rounder than the than the standard 104 end links I may do a short video showing this next week
The clasp of my 3-year-old H link Sinn bracelet doesn’t always stay in place. Swimming in the sea recently,, a heavy wave nearly took my 556 off my wrist. Any suggestions?
@@ClickSpringReview Thanks for such a quick response. I have tried bending it, but that isn't a great solution for such an expensive watch. This video highlights the problem ru-vid.com/video/%D0%B2%D0%B8%D0%B4%D0%B5%D0%BE-UdW1i-YglSc.html
Hi, do you know how much the newer H link bracelet with hex screws weighs , I think the 103 bracelet is the same as the 104 which I want it for. Thanks
My EZM13 has the newer H-Link weight is 87g for my 7'' wrist were as the older is 70g , The newer feels a lot more solid PS just for fun my EZM 1 H-link only comes in at 37g in fact the hole watch is only 98g :)
@@ClickSpringReview I'm sure it would, I'd have to try it on in store and get it sized then see how it fits as I don't mind it being a little loose on the wrist , thanks 👍
Hi sir I wouldn't call it clunky the new one which is coming well be clunky as people want a on the fly adjustable machined clasp , The beauty with the stamped one they have now its thin only around 2mm thicker than the bracelet
I have a Sinn 358 w/ fine link. I love the look of the fine link but HATE that butterfly clasp. The edges are sharp, dig into the flesh of my wrist and leave imprints
To be fair JG 99% of all butterfly class are the same looking only real big difference some of the cheaper ones open with just the push of one button for safety two is better
I wouldn’t say it’s crappy I have the same type on my old sub and new Breitling Colt . It working really well but there are better ones but they cost 3x there . A Sinn H-Link bracelet costs less than a new Breitling clasp again