Remove the screws holding the back of the TV on Once the back cover is off find the red lead coming from the tube itself and following it to a circuit board called the G2 If you look closely, there are 2 plastic screws each labeled "SCREEN" of "CREEP"; and the other is labeled "FOCUS" The one labeled "SCREEN" or "CREEP" is the one you want to adjust. Turn it just a hair clockwise (maybe a little more depending on the severity of the problem) until you see a picture. ;-)
@mrlichenstein Sony tv's built around 1995 had tube problems.The picture will start flashing off and on. We used to go out to customer's homes and adjust the screen control on the back but it's just a temporary fix. I don't know if Sony monitors have this problem but sony tv's do. Used to manage a tv repair shop.
Ours is also a 32" Sony Trinitron (KV-21X5U) - had it since early 90s and has been great to us all this time - excellent sharp picture, better than many out now. We just had the exact same problem - the other day it made a small 'pop' and the TV suddenly switched off. identical symptoms now: standby light blinks but picture never comes up. Any advice? If it can be fixed reasonably cheaply then I'd rather not pay for a new one - as this time last week it was still offering a great service !!
@mrlichenstein didn't know that...thanks for the info...I'm now 62 years old and have been messing around with electronics a long time but learn something more everyday.
@whiskeyify I wouldn't be so sure. I have two Dell branded Trintron computer monitors and they are still chugging along and strong. Only issues I've had with them is the screens will gradually get brighter and brighter. I do have access to software to keep the screens down and looking excellent. ;)
@whiskeyify As far as I know my monitors don't have bad tubes. They get bright because a major bug in the firmware for the monitors. The computer monitors made between 2000-2002 suffer from it. The firmware is designed to compensate for the aging of the tubes and it works quite well. Unfortunately, it also increases the G2 voltage after every adjustment and this increase in the voltage results in a brighter screen. So far I've had to adjust my monitors twice and it's almost time for another.
It's a SONY. That's the problem. Sonies have a "false front", where the outward appearance, as well as excellent picture and sound quality make it look like a high-end set. In reality, it's built with sub-par construction, and low-quality parts. Sony has always ranked high in initial quality, near the bottom of the totem pole when it comes to reliability.
Good old sony not the high quality it used to be...the tubes go bad. Just open the back and turn up the screen control. you'll see a large square black box with 2 adjustments....one focus and other screen. This is the high voltage transformer...if you scared use a screwdriver but I have never gotten a shock there...
the blinking is a code for the problem ,look up for the service manual pdf file see what chasssis the tv is and in there you will find a list of blink codes and the meaning of that code . ex 4 blinks = error on the virtecle sync line, or something else ,and that makes it easy to fix the problem do some diging and you will find the answer , i did with my sony crt tv ...