The CZN-15E sound sensor with microphone is able to detect sound. This sensor or for example used in a so called "clap sensor". In this tutorial I'll explain how you can read the sound sensor, and plot the result on the Arduino IDE's serial plotter. In order to draw this chart we need to process the sensor data with a technique called sampling.
The plotted amplitude is the amount of sound sampled over time. It does NOT represent a sound wave. The sensor is binary, it only measures if there is sound or not and is therefore incapable of determining sound frequency or amplitude.
The Arduino for beginners tutorials series guides you through the world of Arduino. A video is around 10 minutes and shows you step-by-step how to build the circuit and write the code. The website contains the course material, circuit diagram, Arduino code and shopping list of all the components used in the tutorial.
⬇️ Arduino code, circuit diagram and part list arduino-tutorials.net/tutoria...
👉 More tutorials and projects on arduino-tutorials.net
🇳🇱 Deze tutorial is ook in het Nederlands beschikbaar • 🇳🇱 GELUIDSSENSOR OP SE...
CHAPTERS:
00:00 Introduction
00:16 Components
00:26 Sound sensor
02:09 Building the circuit
02:40 Arduino code - part 1
04:08 Arduino code - part 2
COMPONENTS
🇨🇳 Arduino Uno (clone) with cable - AliExpress
arduino-tutorials.net/r/Jd28hF
🇳🇱 Arduino Uno (clone) - Opencircuit
arduino-tutorials.net/r/8237Hd
🇳🇱 Arduino Uno SMD (original) - Opencircuit
arduino-tutorials.net/r/Ud29dh
🇳🇱 Arduino Uno Chip (original) - Opencircuit
arduino-tutorials.net/r/Jd82ha
🇨🇳 Jumper wire assortment (MM/MF/FF) - AliExpress
arduino-tutorials.net/r/Fh378fg
🇨🇳 Jumper wire male-female - AliExpress
arduino-tutorials.net/r/sjf83h
🇳🇱 Jumper wire male-female - Opencircuit
arduino-tutorials.net/r/a7DH2g
🇨🇳 CZN-15E sound sensor - AliExpress
arduino-tutorials.net/r/2387yD
🇳🇱 CZN-15E sound sensor - Opencircuit
arduino-tutorials.net/r/8374HDv
VIDEO SUMMARY:
In this tutorial Bas is showing how to use a sound sensor to show audio on the serial plotter. He explains that the sensor captures sound waves with a microphone and translates them into resistance which is the same as the amount of sound. When there is low resistance, the sensor sends 5V to the OUT and when there is lot of sound it sends around 0V. The potentiometer on the sensor can be adjusted to set the level of the boundary that determines whether the signal will be seen as LOW or HIGH. Then, Bas demonstrates how to build the circuit, connect the sensor to the Arduino, and run the code. To display the intensity of the sound, he shows how to use the serial plotter. He also mentions that he changed the code to sample the audio and use millis() to measure the elapsed milliseconds since the last time.
#arduino #BasOnTech
13 июл 2024
