speed control of BLDC motor using PID controller 

Very useful video! Thanks a lot, and good luck!

in order to get exact result put the value of dc voltage to be 47.89v and the value of gin to be kept to -30/pi good luck ✌✌

Hi could yu tell me where this truth table comes from as my model won't work as yours does, sure it's to do with truth table?

How do you import the truth table value into the model.

Hi! It was helpful. Can you provide the source for truth table of the decoder used or any more sources to know about decoder used in BLDCs.Thanks!

please any help how she did to get the PID values ?

Can you do this with dc servo motor?

Which version of MATLAB are using

Hi! May i ask how to get the value of kp,ki, and kd?

In the decorder circuit, the second wire connected to the second input demux should be connected behind the NOT gate and not in front of it, the gain should remain the same, 30/pi

Decoder circuit how to add truth table

why you didnt change the PID parameters?? What kind of methods did you use?

Do u have base paper ? Can u send the base paper link..

You are trying to do in future you will get succeed keep go on

Can i get the simulation

Then how when we remove the pid then the result can provide please

I tried too, but couldn´t the result as you got. Walmir Brazil

same paremeters are missing, ı coundt get the result

I don't have the correct output even I edited it. Can someone tell me about the value of PID, Sine Wave, and repeating sequence? Thanks a lot guys 😁

I tried,but I couldn’t get the result as you got.I think some changes you made which is not included in this video.

To all, who are not getting desired output... Its decoder subcircuit is a complete mess, that's why it's not working... Get a right decoder circuit for Hall sensor anywhere from Google.. the circuit will run nicely.... After that, you can change the parameter values of PID CONTROLLER to get better response. All the best😊.

how you choose the value of gain .

For all those who aren't getting the right output.. Keep input dc voltage low upto 47v and keep the gain block value -30/pi instead of 30/pi...this way you will get the output as 499.5

Keep gain block gain block value -30/pi and correct the decoder circuit from ru-vid.com/video/%D0%B2%D0%B8%D0%B4%D0%B5%D0%BE-irBoN1RJkO4.html. The Second line should be connected to not gate input instead of output.

👍

Mam How did you paste that truth table there? 27:34

Hi mam the video is very useful but what's the logic or truth table you are following to make a decoder at 23:04

Mam plz share the simulation link...

don't put -30/pi instead of 30/pi. just change NOT gate at 27:34 . only apply not gate to upper wire don't apply on both the wire.

podu maja than inimae ithan yen final year project uh....

Mam please tell me fast tomorrow test

Can you send me a files?

results are not matched when i am trying to make its simulation

What is the purpose of sharing this videos 🤣🤣🤣🤣🤣🤣🤣🤣Thank GOD, If you don't want to share the values of PID, Repeating sequence 😅🤣Many undergraduate students are watching and wasting their times.

This video is waste of time

I tried too much .but I didn't get output.How to contact you