Spitfire MkIX guide 5.1 

But is the wing strong enough when it’s joined together at the middle with only CA glue? Not even a carbon fiber spar 😧!

Damn that's a beast :) Well done!

Vyborne video!!!! Dekuji

Camera angle should be improved? Top view would work better

What layer height is applied to this 3d-print? How long took the print procedure for the whole plane?

Do the ducts under the wing go opposite for each side or was this a mistake?..

What kind of filament is used for this 3d print as well what kind of glue? Thanks!! ☺️

Wouldn’t you know it.....run out of accelerator right when I’m ready to join the two wing halves...😢

I bought 3 planes from 3DLabPrint but will not be supporting them anymore because the designs just keep getting crappier. The BF109 is a good design and has spars for wing support, but the rest don't and CA glue alone is not going to hold those wings.

Also, anyone printed and hit the skies with this one? I’d be interested in your motor/esc/battery setup 👍

The wing should’ve been connected with a Carbon rod for transportation

Пожалуйста сделайте русские коментарии