No video :(

Spoon Windshield Banner Installation

Подписаться 350

Просмотров 13 тыс.

50% 1

Our tips for DIY Spoon Banner installation.
Please ONLY purchase your Spoon Banner from an Official Spoon Dealer as there are so many fake banners out there on eBay etc.
Take your time, "measure twice, cut once" as they say.
Please note, using any blade on your windscreen can scratch the glass if you are not careful.

Опубликовано:

24 авг 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 7

@GK5_ 4 года назад

The video looks like it was filmed in 2005

@adamgurule1458 2 года назад

It's alot easier to trace the pattern on the back of the banner first, cut and install

@Triple259772 5 лет назад

I don’t get it, how did you pull that strip? Is it built with serrations?

@GaijinGarage 4 года назад

I normally take a steel ruler (the large version) and take off one 'slice' at a time using a 'box-cutter' / retractable blade knife (always use a brand new blade!), normally 2 slices is perfect for EG/EK/DC2. The advantage of doing it this way is that you can adjust the height (from max to legal). for those with Low Position Seat Rails and racing seats and those with a full cage installed, it's handy to have it hang down quite far.

@sidthesquidtoombs3132 5 лет назад

How were you able to pull a perfect strip off without it stretching or moving its height.... i get the measured cut, but still dont understand how that line was so clean from pulling it

@GaijinGarage 4 года назад

as the saying goes "measure twice, cut once"... take your time and ensure cuts are made cleanly through the vinyl - always use a brand new blade also. 'Squeejee' the fluid out so the banner is held onto the glass - you won't be able to trim the banner until it's fixed down properly.