Sprinter Horn Upgrade Install (Updated) 

So after watching this, of course I had to go to your site and buy it. *UPDATE* Just installed and it took like 20 minutes to complete. Hardest part was not breaking or cracking the grill clips along the bottom. Everything else was easy-cheessy!!! Thanks for great video Jon!

Never thought about it until i saw this video. Now I want one for my Sprinter!

Just got done installing this. Good video, but one small detail is missing (at least on my Sprinter). The original horn harness does not just unplug. There is a locking mechanism that needs to be released. I had to remove the original horn to get at it - no problem, it was just a small bolt, you would never see the gray lock that needs to pop down without removing the original horn. This was on a 2024 Sprinter. Other than that, took about 30 minutes and works great. I had a bit of trepidation removing the grill, but it does come off and go back on easier than one would think.

Jon, I enjoyed seeing this horn upgrade product kit and ordered it right away assuming it would also fit a 2016 Sprinter. Before I open the box however I thought it best to check with you to see if there is going to be any problem or possibly the need for an alternate mounting bracket or wiring connections? Enjoy all your videos!

Blue wire was 12 volts on my 2020, so I connected the blue wires on top per the included horn installation directions.

BOSS sound. Yes Sprinter horn was the very last thing they thought about and then decided , screw it we're done. Low profile ZIP ties, never knew.

Another great video. When you cut the end off of the low-pro zip ties, won't it still have a sharp end, just sticking out at an angle? I've found the zip tie cutter "gun" for the normal ties to be practically indispensable... It cuts the end flush with the clamp. Not always easy to reach it into where you need it, but I wish I had bought one much earlier! For the hard to reach ties, I use a box cutter and cut along the clamp to get a flush cut.

i need this horn, for NVC3. Isn't the only difference is the mounting bracket tabs need to be bent 90 degrees?

great vid. do you sell :Mounting Bracket (mounts to factory holes) Owl Direct Connect wiring harness (plugs into the factory harness) separate?

Thanks for the video, I’m going to get myself a louder horn, why do Mercedes put such a small horn on such a big van ! 😂🤣

Yup That’s a real old Oldsmobile American type horn.

Why not mount the horns without the bracket? They got a metal tab with a hole. Will look cleaner and less parts.

My grill has the sensors for the radar and cruise control. Didn't see any on your grill.

Can you send me the link where you got this horns from please for 2020 70 thanks

Where can you buy that awesome bracket and wire harness?

😂😂😂😂😂😂😂