Saludos Christian, estoy trabajando en este módulo pero en la parte de usar el comando de encapsulation me da un error referente a la interfaz de g1/0/1 y dice aborting al final. Que podría haber hecho mal?
@@romeroc24 Estoy utilizando el rango de la interfaz: MULII-1 (config) #int range gl/0/1-4 MULTI-1 (config-¡f-range) #switchport trunk encapsulation dot1q • Interface range command failed for GigabitEthernet1/0/1 command failed on interface GigabitEthernetl/0/1. Aborting 🔴Este es el error después del comando.
Hey Christian, what do I do when i get the text below? MSW-1(config)#int range g1/0/1-2 MSW-1(config-if-range)#switchport trunk encapsulation dot1q % Interface range command failed for GigabitEthernet1/0/1 % Command failed on interface GigabitEthernet1/0/1. Aborting
@@romeroc24 No, it does not. I am having the same issue. The MSW-1/L3-SW1 device does not allow the command switchport trunk encapsulation dot1q. I followed exactly what you did and received an error.
I have a complete different table than yours but I am trying to work along with your version. In step 2 of configure trunking on the ether channels around 27 minutes and 6 seconds of the video. I enter the command and receive the following feedback, is there any possible way to tell me what is wrong and what I can do to fix it? Here is what i have enter and the feedback: MSW-1(config-if-range)#int range g1/0/1-4 MSW-1(config-if-range)#switchport trunk encapsulation dot1q % Interface range command failed for GigabitEthernet1/0/1 % Command failed on interface GigabitEthernet1/0/1. Aborting
when i go to int g0/0/1.40 and the others 50/60 ect. i can't add ip address it says the ip address overlaps with another vlan , i searched some people say i need to do in int port-channel 1/2 switchport mode trunk encapsulation dot1q in the multilayer switch but when i do that it does not want to accept the command. do you know how to fix ?
9:10 how to check to which port of router is switch connected? When I click on red triangles right and left button of mouse only window with allert appears and says "Disconnect is locked"
great video except it didn't let me set the encapsulation on the ports or port-channels. I did everything else and the pings were unsuccessful. i followed everything carefully. any tips?
same thing happened to me. I was trying to figure out where i went wrong and the packet tracer closed on me 😩. I ended up getting an 89.1%. What grade did you get after you submitted the assignment?
@@romeroc24 Nosotros apreciamos el esfuerzo, sobretodo yo que soy alumno, profesor, autodidacta y todo lo que esto conlleva. Mucho ánimo, saludos desde España.
@@ronaldhernandez0812 bueno, puedes ir viendo la lista de reproducción ru-vid.com/group/PLdtRZtGMukf7eey3OLb-KRM6_LoUYjd-8 ru-vid.com/group/PLdtRZtGMukf5j92aHe9lqVaiLIxtt2Sbi