Stop The Beast! - The T-series Of Terror - BeamNG Drive 

Then you can dump them out onto your pursuers >:)

More points depending on which hunter. Double points for Laddo.

took the words right out my mind!....they really should put one back in survive the hunt make it a def hunter each time they would be forced to gard him n the golden snitch has to be in the fastest car they like

yes i know the game could end to fast. yet why not just do another one if it ends in say 5-10 mins.? ya ya ya i know ppl dont watch things over 40ish mins youtube but hey the failrace army will EVERYTIME. thanks again for givin me my money back since you couldnt get them to the usa at the time as well

@@anperson8329 If it's Stevie or Amy it doesn't count

I wonder if the bed dumps, then just drop Laddo off a cliff.

Thought it was funny when Amy said that he went from dangerous driving to kidnapping.

Most of the car, except the radiator and fuel tank is behind the ear axle, so it's good with front impacts.

@@jwalster9412 That is the thinking lol

Surprised y'all didn't tell Joe to pit his left box while he was in the tanker. One nice pit and he's going down the cliff.

He also was getting Laddo-napped he doesnt count lmao

Alex hasn't truly escaped until he's left all the hunters behind, Laddo's logic is flawless

I think it is the perfect balance of quality and price for this kind of content.

wouldn't have it everytime,but on rare ocasions it's not that bad,i prefer the normal setup though.@@FelixUmbra

It fine

I'm watching 2160p 60 🤨

I think the upload partially fixed the issue.

Que banjo track?

Back to the basement for you

Laddo: *_*chuckles*_*_ "I'm in danger."_

o_O;...

ˈt͡ɬɪ.ŋɑn mɑx (i used a translator for this but still lol)

LMAO

Scrape 'em off, Jim!

Hey, sometimes you just cant ingore the urge to commit vehicular- mansaughter-by-cabover

If there’s a race the flood tomorrow I may pop

@@meandthepotatoes4916 Amy did a 3+ hour BeamMP Parkour stream as well if you're feeling deprived

Hopefully, assuming Alex sees this, it'll help next time they're messing around with the truck

Haven driven tanker trailers for nearly a year I was just waiting for the truck to roll the entire 3rd run

@@blargleschnartz He did say that they'd started out with it full up but it kept falling over so had to go down to roughly 1/3rd full... Also I was going to say something about the gearing also, was going to explain it a little different though so may still make a separate comment unless someone's beaten me to it.

I kinda think the two things are related... things that you set up once and then forget forever tend to... also get forgotten when you get a new machine XD

Gevril T series "destroyer" is it's name bro.

*quietly yoinks bumper*

It did used to be different but they implemented that weird change with the remaster. Old type was essentially like going up and down through the gears on a conventional 10-speed (like someone posted an example shift pattern for on Amy's discord recently) but the range shift was handled for you. I'm not really sure that this is, it's kind of like a... 15-speed?? (if we consider a variant of the 13-speed that's instead based on the 10 and with all of the high range gears splittable), but it's locked into high range and the total spread of gears is somewhat wide and biased short to compensate. Luckily for this kind of use where the truck is running relatively light and you don't need the intermediate gears (which would have been the odd numbered ones previously) to get started or keep steady speed uphill, you can just run it with the splitter in the high position and shift it like a (presumably dog-leg) car type 5-speed. It's definitely a pain in the backside even on keyboard, if you're trying to do it properly with a heavy load and it's basically impossible to hit the gear and range combo at the same time. I'd have hoped that the new system where it stays in neutral as long as you hold the key may have helped (along with the manual clutch override) to perform more realistic shifts without a H-pattern accessory, or something could have been done where you could more easily signal a block-shift of at least two gears with a double tap or whatever. Or it automatically went up or down the range and moved the virtual gearstick to the most logical next position in the pattern when you tried to shift up at the top of low or down at the bottom of high, plus adding three-range boxes to have proper gear splitting in high... But presumably this was the best compromise in terms of ease of use after trying various things? Still, I'd like there to be a selectable alternative for having 10 directly selectable gears like the classic T-series, if there isn't one there already I might just make my own.

I always get such vitriol and absurdity saying this exactly about most videos and games. People all clamber for 1080p 60 frames or 4k 60 frames. Like look man you got spoiled on quality, 720p is fine. Our eyes don't need more than 30 frames even. The whole argument is absurd and partially why we have more expensive games with lower content quality. Studios try to design games to run on as much as possible within reason. Tell them to target such high sustained numbers they are gonna charge more.

@@Aliyah_666 He was talking about the recording, he was definitely running the game at higher resolution and framerate, possibly QHD. And you can definitely tell a difference between 30 and 60, and indeed 60 and higher rates (heck, things are even noticeably smoother in Windows when my montior's at 240 instead of 60), though there's diminishing returns. Still, for watching something like this, it's perfectly fine. Lived most of my life with 576i50 TVs, and gaming at no more than 800x600 or maybe 1024x768 with systems where 30fps was pretty good going. And like someone else said (I think maybe on HtS), consistent moderate framerate is better than swinging between 60fps and 6fps because the hardware can't deal with the rendering when there's a lot going on. And I tend to have Beam locked at 40fps (and 1080p windowed) as that seems reasonably smooth to me without causing my laptop to melt into a pool of undifferentiated sludge, so 30 wouldn't be so much of a downgrade, at least after a little time to get used to it (it'd seem a little crunchy in comparison at first)

The Stambecco riot van might be interesting too

There's a mod of the T-series which allows you to make a T-Series with three driven axles in the rear and two steerable driven axles in the front. Oh and you can set it up to have electric motors with a diesel generator which allows it to have somewhere around 2000 horsepower in total. That thing is honestly unstoppable.

Beam doesn't really have proper snow or other dynamic terrain... "yet"... is the thing. Heck, weather is only seen as a mostly cosmetic thing, and then in a few mods that specifically include it. Nice idea but it might be a few years until anything like that happens, and I have to wonder if that might need such a radical overhaul of the engine that it would justify making a whole new-new-generation which would be a separate thing at cost (the money earned off initial purchases of the early versions can't sustain free updates forever, sadly)

He's a hostage!

ok can't edit that for some reason, but i wrote that having got mixed up with hunt the survivors. This may still go up but I haven't seen it yet.

The trick on diesel locos (which have that kind of problem in spades given how their airbrakes work and the sheer amount of air needed to operate a long train) seems to be to put it in neutral (meaning in this case the generator isn't connected to either the forwards or backwards circuits on the motors) and rev the engine up. Compressor being run directly off the engine crank = brakes recharge and release nearly 5x faster with it wide open at ~950rpm than idling a little below 200. Probably don't need to redline it on a road vehicle but manually keeping a higher than standard idle should help.

And it's not made of cardboard this time

They tend not to use custom maps other than a few limited small scale ones (maybe as a concession for some players' PCs not being all that strong), and you'd probably need something a bit larger scale to have a worthwhile distance. He managed to loop a couple times around the majority of the Utah Extra map with most of the trucks here after all. Possibly Italy may give a suitable challenge due to the hills, and the winding roads making it take a lot longer to get around the island than if you went in a straight line, but it really seemed a bit too cramped for an enjoyable experience last time they did STB there. May be worth seeing if there's anything out there that would give a good long run without being too boring and predictably straight-line, and offer a choice of start and end points that could be randomised, without causing e.g. Russkiye's computer to explode.

except the auto versions

@@potatoes5829 well it wouldn't really make sense, and the shift logic as it stands would have absolute kittens trying to deal with it, so it's reasonable to just have that as a more conventional high-gear-count auto. I haven't investigated but wouldn't be too surprised if the ratio progression works out about the same.

@@tahreyfrom what I can tell, the top speed is roughly the same, so I would imagine the rest of the gears are similar too. I imagine most truck drivers don't use hi/lo every time when its not necessary either.

@@potatoes5829 Nope, that's right, as far as I've heard it's standard practice to skip gears when running light. There's even videos of drivers doing that in unladen tractor units and absolutely destroying otherwise quick cars following them, because there's more than enough power in reserve to scoot the thing along with haste even at the low revs met with after a block upshift. Maybe only changing gear 3 times after starting from a standstill or a slow roll, and blasting smoke the rest of the time, all the way up to decidedly Police-upsetting speeds. As for the auto, someone said it's actually a 6-speed, and if it's torque converter based rather than automated manual or DCT, I can easily imagine it's got a similar top gear but the lower ones are a little wider spread than what you get with the split manual, and don't go down quite as far, maybe not even as low as 1H. Like how things tend to be in auto vs manual car transmissions. Hopefully doesn't lose too much performance as a result, though as it's kind of like pitting a 3sp auto against a 5sp manual I wouldn't be too confident about it. A 7 or 8spd might have been more cromulent.

@@tahreynah I believe its a 5spd torque converter auto. atleast thats what it feels like to me ingame, I could only count 5 gears, and the vehicle could accelerate during gear changes (or atleast it felt like to me) which dct or auto-manual can't do.

I may be in a bubble but I can think of at least six (seven?) other fairly popular channels that regularly post Beam content without putting any effort in... Alex just hasn't done it for a while as most of the best stuff is multiplayer, and his old PC couldn't take the strain

@tahrey I know about the other content creates, I was just saying compared to other games, it's not as popular as it once was, even tho personally I love the game, and as far as Alex continuing, I just wanted to express my love for this video and hoped he turns it into a series

@tahrey also if you have any recommendations I'd appreciate it, I do love the game and like to watch videos on it so if there's any creators you'd recommend I'd like to check them out