Swept Blend in-depth | Ramsbottom safety valve in Creo Parametric 

Do you have any future plans on covering assemblies and multibody parts? Also a quick tip explaining hole options in parts? Such as linear and diameter etc... Thank you for all the hard work please keep it up!

Yes, it's coming soon.

I have considered it 50 degrees as it gives me the best result. Actually it should be tangent there. But I was getting some error when I was using tangent condition there. So I considered 50 degrees to get the result.

I have taken it as approx value

I didn't understand your question.

Sir ..you make sketch from a 2d drawings..where all dimensions are given..but you take dimensions very fast from that drawings . Our mind don't get it.

You can pause the video sometime in between to understand the topic better. I don't indicate dimensions all the time to reduce the length of the video. That is why I keep the drawing open all the time on the screen. Hope you can understand the reason.

Ok sir ji ...your all videos are great upper thanks a lot.

I have considered it 50 degrees as it gives me the best result. Actually it should be tangent there. But I was getting some error when I was using tangent condition there. So I considered 50 degrees to get the result.

@@CADxTraining understood thank you for the explanation

This is done by video editor

@@CADxTraining Thank you so much sir, Your videos are so helpful.

There is some technical issue. Uninstall creo and try to reinstall.

@@CADxTraining it occurs every time i reinstall so many times

You try any other version to check

@@CADxTraining i checked 5 6 7 8 version

Than this will be the graphics related issue

There is no direct method in Creo parametric to do this. You can only do this by adding a draft entity.

Just right click will not work. Right click and hold the right click, you will get the options.

If you are following swept blend method then at the rib using extrude.

@@CADxTraining got it sir ..I used The extrude feature now .. it worked ..but can I know the reason sir why rib feature is not working in swept blend method

The surface generated by swept blend is different than extrude and revolve.

@@CADxTraining yes sir while doing swept blend .. the surface was not fully closed to do rib feature ... So like u said I did extrude instead of rib ... Thank u for helping me out sir .. learning a lot from u daily

Keep learning