For the codes you need to take cooy of current tune, load it into the winpv on the computer enable target tune on the current tune , save that into new slot on powervision reflash the bike with target tuned enable map and should be good to go, I called them two days ago and was given those instructions vs the old method of sending them your current to have done and sent back
Does connectors for the o2 and harness goes on the bottom of the frame then up wards at back above tbe starter. Doesn't go above the frame. Also. You .Just disconnect the old o2. Sensor unplug them
@iginogasparini3369 You must remove the gas tank and place the TT harness in the main harness tray. Yes, simply unplug and leave the factory O2 sensors in place. From start to finish, the process takes about two hours. The one thing I would recommend is to use a crow foot adapter to remove the bungs from the exhaust pipe.