Same thing was happening with the m&p .40 2.0…. I couldn’t even load a full mag at first the last round wouldn’t go in for nothing… then I let the mag sit for a few days then loaded the last one in and it finally went in sit for a couple days after and the magazine was smooth and a lot easier to load and not one malfunction
Damn it!!!! I was really wanting to purchase one of these!!! What is it about the 10mm that makes it so damn finicky??? My G20 Gen5 even suffers from failure to feed issues as well!!! 🤬
For reasons unknown, I like the Underwood Xtreme Defender and Flat Nose Black Cherry Coated in 10mm, but like the Grizzly it's expensive and I haven't shot any bears with it, so I don't know (for sure) that it works as advertised.
That is disappointing. I would expect it to run everything out of the box. I have a 1.0 40 cal. & A 2.0 40cal. We have or have had a # of Shields(9, 40 & 45) in our family with only 1 failure to feed in many thousands of rounds. I have given this very gun some consideration. But going to wait a bit.
Found the best way to break guns and mags in is to store in safe with fully loaded mag +1 in the chamber. This helps break in the mag spring and extractor spring. Let sit a few days or longer. Will then eat any ammo you throw at it.
You're not the only one with issues S&B ammo. I had a couple failure to feed and 1 misfire shooting out of a Glock 20 gen 3. Never had issues with double tap, federal, HSM bear loads, or any 10mm target loads. S&B = shit & bullshit ammo 😂
