The easiest way to make a home wind power generator.Build a low rpm generator at low cost. 

Very welcome

You are welcome!

Thank you, but I am currently working on steam turbines and will definitely do so in the future

Also for you

The output power of this DC generator does not change at all, all we have done is increase the voltage with a slow rotation If you use arc shaped neodymium magnet from N42 to N50, the power of the generator will be very high. Thank you for your good comment

excellent I also subscribed to your channel Good luck

Thank you for your nice comment In the video, I have explained that in the machine method, we have to have two points of connection But in the manual method there is no need for two connection points and in fact both methods are the same If you want, watch the video carefully

Thank you for your comment Because the current is DC, if we change the poles, the negative becomes positive, and this is not so important, and the important thing is the amount of voltage or current that is shown. As for rotation, it doesn't matter which direction it rotates, only the positive pole becomes negative To twist the wire, we continue the same method for the entire commutator until we reach the starting point

@@fixedfocussolar Stupendous, my man. Thank You so much. I have to look over your vid again because I'm not that familiar on how to calculate what you did. Thanks again.

@@robinhooper7702 👍👍

​​@@robinhooper7702take a DC motor, test it's voltage when it's going around 300 rpm (depends on how fast your wind turbine will spin is an average wind) take that voltage and multiply it till it's around 15 volts. So if the original was 3 volts multiply 3×5 to get 15. Next unwind one of the coils and count how many turns and record where the coil was and what comutator clips it's connected to. If the original coil had 10 turns to achieve 3 volts you need 5 times the turns to achieve 5 times the original voltage so original was 10 turns to make 3 volts so you need 50 turns to make 15 volts. These numbers change but the math stays the same. 1 find your wind turbines rpms 2 find your motors voltage at that rpm 3 multiply that voltage till it averages 14-16 volts 4 unwind the motor and count the turns that made the original voltage 5 multiply the number of turns to achieve the wanted voltage 6 do it to it This works with ac motors as well

It depends on the location of use and the power of the wind turbine and the incremental gearbox

Well done to you But I said in the video that the core has a glaze color and does not need insulation

@@fixedfocussolar I've wound coils experimenting and never found that glaze was adequate not all thee time, Soon as it heats up. ????

​@@CMAenergy Heat-resistant paints can withstand temperatures up to 400 degrees Celsius. These types of enamel paints are used on most electric heaters.