Today we will install the interior door using the simplest version. And this simplicity lies not only in the fact that the boom is using the simplest tools that usually exist in any home, and if something is missing, it can always be bought inexpensively at a nearby construction store or on the market. And also in the fact that instead of the complicated mortise lock in the installation, we will put the lock-latch and instead of the hinges we put the overhead loops.
In our case, this is a lock-latch.
We measure 1 meter from the top and bottom and sharply sharpened pencil on the angle piece making the marking from the end and from both sides, we find the center of the drilling equal to the distance from the end plate to the axis of the handle (usually 65 mm) and nakernivaem that the drill at the start of drilling did not escape.
We do not even have the right to make a mistake even for 2 milimeters.
With a drill bit, drill a hole under the body of the lock-latch. We'll stop here. The diameter of the lock is 22 millimeters. There are kits for installing locks. There is a crown of 50mm under the handles and a 22mm drill bit, but if you drill a 22mm hole, the lock does not get into this hole. Some try to force the lock into this hole. Which leads to the fact that the door frame just bursts. You can not do this.
Well approached, would be the size of a 23 mm drill bit, but such drills are not for sale, there is 20mm and the next size is 24mm. We buy a 24mm drill and we grind off 0.5mm from the edges.
and where the gaps are not the same.
Convinced that everything is done exactly, put the gaskets and zapenivaem. Gaskets should be prepared in advance, I use old cases from the Boers. They have a thickness of 2.8 mm. will suit us.
While the foam stiffens, I'll tell you why I chose this particular door.
I had six reasons for this.
The first reason is the color. Because the dark doors in the interior look better and more expensive. Than the light.
The second reason is glass. Doors with glass make the whole room more stylish and it seems that the design of the room was handled by the designer.
The third reason is the covering of eco-wool. Although of course there is no ecology and no veneer here near to lay. It is a laminating film with an effect of natural veneer with increased durability. A prefix eco stands for economy. but still the film is high-quality and durable.
The fourth reason is a besproblemless technology. According to the usual technology, the lining that covers the surface and the end of the door in the corners is sometimes peeled and lifted. On the frameless technology, the cladding as it envelops the details of the door and there are no edges that could be peeled off.
The fifth reason - a telescopic box and trim. Which allow you to do without the expander of the doorway.
The sixth reason is the price. door with a casket and platbands cost 4100 rubles.
The foam froze. We remove the gaskets. and do it very carefully and carefully so as not to scratch. We open the door, see how it turned out, and if everything is fine, we install
Installation of handles and lock.
Installing the lock with handles
If everything works fine, the gaps are OK, the lock works, the job can be considered finished. The door is installed. Congratulations.
On this positive note I want to wish you and your families health, success, good repair. All for now.
13 июн 2018
