Good Afternoon. I recently ordered a new driver's side seat cushion and cover from www.theseatshop.com/?msclkid=... . This is my install video, I hope you enjoy!
I watched your video. it gave me ideas. when I replaced mine today, I ended up not taking the seat out at all and was able to replace the foam and the seat cover without removing any screws or brackets. But, I didn't find any pennies since I didn't get to take the seat out.
My next seat will be a Chevy avalanche since my van is so much better now. I looked at my truck. No wonder why my back has been hurting. I bet my vans seat is 3 inches higher now. Thanks.
@@everjeff So you have to aeperate the back and the bottom parts to make it? And how could you get the splint form the armrest on place, after pulling the back cover over? 🤔
@@rehab4everybody yeah they all unbolt and I did have to take a razor and make a small x to allow the factory bolt to poke through the vinyl material but it’s not visible when you put the arm back on.
The chair lever is the part that I had to make the slit for. I only replaced the bottom seat cushion. The actual arm piece is attached to the top part of the seat which I didn’t have to disassemble for the bottom seat install.