Aeromodeling : this is the SwifTic with.
Free plans / 3D prints of the SwifTic construction plans :
cults3d.com/en/3d-model/vario...
0:00 • 1 - construction info
6:39 • 2 - EPP construction
12:36 • 3 - Bonus if you don't have any 3D printer
Hi,
To construct the SwifTic flying wing you will need :
-EPP 6mm (2 sheets) : www.guixmodel.fr/modelisme/ac...
-Or Depron 6mm
-Carbon ring 5mm : www.flashrc.com/kavan/3178-tu...
- Epoxy glue 5 min
-Cyano + activator : www.flashrc.com/robbe/27674-l...
- Carbon rush 2mm : www.guixmodel.fr/modelisme/ac...
-Guignols : www.guixmodel.fr/modelisme/ac...
-Screeds : www.flashrc.com/mp_jet/26805-...
- Engine+ ESC : www.flashrc.com/dualsky/20058...
- APC propeller 7x5 : www.flashrc.com/apc/286-h%C3%...
-Lipo battery 850 mAH ou 1000 mAH : www.flashrc.com/tattu/28631-b...
-Plugs XT30 or XT 60 or depending of your battery
- Engine support if no 3D printer: www.flashrc.com/ms_composit/3...
-Reinforced adhesive
-balance CG weight: www.flashrc.com/kavan/17362-p...
-Multiplex foam paint (extra ;-) ) : www.flashrc.com/multiplex/232...
And also a radio and a receiver : you can start with a Flysky i6x : www.studiosport.fr/radio-flys...
You can also equiped it for FPV. The EPP flying wing for flight in sight , for aeromodeling comes with 325 grammes centered at 17 cm and equiped with 850 mAH 75c.
The SwifTic flying wing is powerfull (and even more if covered and rolled) , but it can also be convenient for beginners (low engine Kv, not covered). The construction is quite simple and quick (half a day)
Hoping to have helped,
See you soon my friends,
Greg from Pilote Aéromodélisme
Swiftic RC Flying Wing: If you want more info in English, please feel free to ask me in the comments section. 😉🛩️
#SWIFT #Aeromodeling #Flyingwing #SwifTic #RCConstruction
The video : • L'aile volante perform...
5 авг 2024