Тёмный

The Trainer  

Motor Age
Подписаться 133 тыс.
Просмотров 12 тыс.
50% 1

#motorage #autel #dso #drivability #engineperformancerecovered
There are only four things that can make an engine run poorly. On this episode of the Trainer, I’ll show you how to use a scope to test one of them!
There's lots more from Motor Age! Visit us at ru-vid.com?sub_...
Show the world you were "Born To Wrench"! Check out our official MA T-shirts:
passthease.motoragetraining.c...
@@@ YES - I WANT MY FREE SUBSCRIPTION TO MOTOR AGE! @@@
endeavor.dragonforms.com/load...
@@@ TRAINING FOR PROFESSIONAL TECHNICIANS @@@
connect.motoragetraining.com
@@@ FOLLOW US ON @@@
Facebook: / motoragemagazine
Twitter: / motor_age
Instagram: / motor_age
TikTok: / motor_age
@@@ VISIT OUR WEBSITE @@@
www.vehicleservicepros.com
@@@@@@@@@@@@@@@@@
Due to factors beyond the control of Endeavor Business Media, it cannot guarantee against unauthorized modifications of this information or improper use of this information. Endeavor Business Media assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Endeavor Business Media recommends safe practices when working with power tools, automotive lifts, lifting tools, jack stands, electrical equipment, blunt instruments, chemicals, lubricants, or any other tools or equipment seen or implied in this video. Due to factors beyond the control of Endeavor Business Media, no information contained in this video shall create any express or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or the information contained in this video is the sole responsibility of the user and not Endeavor Business Media.
The tool and/or equipment featured in this video was supplied by the manufacturer and may or may not be retained by the reviewer at no cost.

Авто/Мото

Опубликовано:

 

31 май 2023

Поделиться:

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист
Посмотреть позже
Комментарии : 21   
@DJ-tn7vj
@DJ-tn7vj Год назад
Hi Mr Pete. You will surely be missed at Motor Age. Thanks again for all the information that you have shared with us. Take it easy
@bekomcar554
@bekomcar554 4 месяца назад
Thank you Pete, every single word is a gem. Your fan from Korea.
@user-uj1xq5bt2m
@user-uj1xq5bt2m Год назад
Thank you for your thematic lessons Greetings from Kazakhstan
@MotorAgeMagazine
@MotorAgeMagazine Год назад
Thank you for watching!
@richardnilsen8950
@richardnilsen8950 Год назад
Comprehension is key I get that from watching You work great video Thanks 👍😁
@MotorAgeMagazine
@MotorAgeMagazine Год назад
Thanks 👍
@philh9238
@philh9238 Год назад
Newer gdi cars can set p219a and p219b codes for cylinder to cylinder air fuel ratio
@brandonsteckler3417
@brandonsteckler3417 Год назад
That's correct, thank you.
@ThunderbirdRocket
@ThunderbirdRocket Год назад
Fantastic tutorial ! Thanks mate !!
@MotorAgeMagazine
@MotorAgeMagazine Год назад
Thanks for watching!
@James-fs4rn
@James-fs4rn 10 месяцев назад
👍 thanks for sharing!
@johnmitchell8925
@johnmitchell8925 6 месяцев назад
Great Stuff as always Pete Now i know why no one wants to pull out the scope
@DavidGutierrez-zi4dy
@DavidGutierrez-zi4dy 6 месяцев назад
thanks!
@bobbybrown8926
@bobbybrown8926 Год назад
thank you Pete very good video
@MotorAgeMagazine
@MotorAgeMagazine Год назад
Glad you enjoyed it
@VashthStampeede
@VashthStampeede Год назад
Wonderful presentation. When you showed the Autel attenuator to the camera, it was a 20:1 attenuator with 10 MHz bandwidth and a rating of 600 Volts maximum. Then you installed what appeared to be the same attenuator in the line of your scope probe. But you set your scope for a 10:1 attenuator and got a flyback reading of 32 volts and remarked it was lower than expected. Had you set up for the 20:1 attenuator in the line, would you have gotten a 64 Volt flyback?
@brandonsteckler3417
@brandonsteckler3417 Год назад
Thank you for pointing out the oversight. It was indeed a 20:1 attenuator and the 10:1 setting was chosen on the scope. Although the scope is now protected from the potentially dangerous flyback voltage, the math is no longer accurate, and the scope is not displacing the voltage correctly.
@Jpilgrim30
@Jpilgrim30 9 месяцев назад
Looks like someone is used to using a pico and the 10:1 attenuator.
@nickayivor8432
@nickayivor8432 Год назад
👍 SHARP Sir Pete Meier Motor Age From Nick Ayivor from London England UK 🇬🇧 ⏰️ 23:01pm
@johnrobinson8712
@johnrobinson8712 Год назад
Good video I guess no sense doing injectors w/o amp clamp & voltage together .
@brandonsteckler3417
@brandonsteckler3417 Год назад
Correct, the voltage shows the command, and the current shows the work being carried out (Or "not" being carried out).
Далее
The Trainer #137:  Putting The Autel Scope To Work!
19:27
5 Tips For CAN Bus Diagnostics | Mechanic Mindset
16:55
Я ВЕРНУЛСЯ 🔴 | WICSUR #shorts
00:57
Просмотров 1,5 млн
Common Rail Diesel - No Start Fuel System Basics
53:01
Просмотров 299 тыс.
The Trainer #126:  Diagnosing Intermittent CAN Codes
28:46
Malo vozim, malo punim 😉🤣
0:16
Просмотров 2,3 млн
STAGE12 200CC FL-R EN ACTION 🧡🧡
0:49
Просмотров 19 млн
5 минусов работы
0:53
Просмотров 646 тыс.
профи на Тракторе Т-16
0:24
Просмотров 2,4 млн