I finally know what those two long screws are for. This is the part that gave me the most trouble. Everything else is an sinch. This is the best video on how to instal pressure regulator spring. Thanks'
outstanding video! just what i needed . read it all through in my GM Vette manual bit seeing someone go through the steps is excellent. THANKS! keep the video camera rolling.
I just saw my problem ! I put the rubber O ring into the groove and then the metal ring on top of that and as soon as I turned on the key gas started running out the bottom of the injector , I suspected the injector was not going down far enough , well I have a feeling it will work a lot better now ! Thank You very much !
Hi there. Was wondering if you know where I can get the replacement kit you used. I ordered one off Amazon that said it fits and everything did EXCEPT the red ish gasket you put where the spring sits on. The one that came in my kit just has a quarter (coin) shaped metal at the bottom, otherwise from where spring is. BUT the original one AND the one in your video has that smaller circle that’s sort of on a swivel. I need THAT gasket. I’d buy a whole new kit if it meant I can get the right gasket lol. If you have a link to where you ordered I would be grateful !
I used an orbital DeWalt sander the sand the planes of the Intake Manifold doesn’t have to be too abrasive and did a really good job. It’s stunk, but I soaked the intake manifold and paint thinner for about a week a lot cheaper than Berryman’s to have to buy that much, Berrymans is about $40 a gallon. in the 1980s about $15 a gallon.