Hi Everyone , for the home blow dart makers here is a great way to make darts , bicycle spokes and I have found buy using insulin pen needle caps and putting it in a piece of coarse sandpaper and turning it around in circles and checking it every few turns it will fit into the .625 big bore guns great . So if you are a insulin user it's a great use for putting these plastic to use .
@@Mex_the_Fox I'm going to say 30% off .... I'm finding they fly truer ( more accurate ) a bit faster , reckon they loose some punch in weight but I'm liking it better
I use bike spokes and the cones from the bamboo darts to make my own darts. Drill a hole in the cone, cut the end of the spoke off so it has a small hook and stick it in the cone and use a hot melt glue gun to glue it in the cone. I also drill a hole in the stun darts and glue a spoke in the tip to use for fishing. If your good with brazing you can braze an Exacto blade to the spoke nut and make them removable so you can replace the spoke when it gets bent.
You can get 2 18 inch blowguns at BudK's for $16.99? I like my Blow guns Naked,....just the tube and the quiver on them then they are quick and easy to use,....longer is better. I'd never hunt with one game is scarce so I'd just use a 12ga loaded lightly and get the meat VS a blowgun that the game runs off bleeding inside/ hard to find. But mostly small game tends to be 30 yards or more that's why I prefer a 12 ga pump with a vent ribbed short barrel and screw in chokes.
I just bought the blow gun. I have it for a day now and have managed to get upto 50 m/s (164fps). 60 m/s should be possible but propably not for everyone.
No I sure don't The idea is nice, however, by hunch is it would be an expensive process to have a broadhead and feral attachment on a very small diameter dart.
