To get one of these Tippmann TMC Paintball Guns visit: www.ansgear.co... For more great paintball and airsoft products and accessories check out www.ansgear.com
Thank you so much for the video. I had just taken apart my TMC that I’ve had for 3 years (used it many times, but never taken it apart), and as expected everything sprung out. Thanks to this video I got it cleaned and put back into working order. Thanks!
My TMC wouldn't recock. My hammer oring was clean, so I was confused. It was the power tube around the pin where the hammer slides into that was slightly dirty, and not that noticeable. Whiped it with alcohol, lube up the hammer oring, gun works fine now
Great video explaining how to teardown. My TMC was machine gunning and wouldn't recock after each shot. Tore it down and lubed the hammer o-ring after I saw the sear wasn't damaged. Runs just like new now!
I took mine apart a while back to fix an issue and used this video. However, i must have lost one of those four little pins. (I only had three, must have lost one) Watched it again and now my gun works thanks!
I have had the Tmc for more than a year using medfed and had to get two time for two reasons repaired but otherwise it a great marker. I think it for pros and new players.
I am super tempted to buy the TMC but one thing that keeps me from getting it is that non-removable stock. Which I get why it's there but I hate not having a choice to remove a stock
If you upped the firing pressure on the grub screw..... and upped the regulator pressure on the bottle. what kind of FPS could you expect... asking for a friend
Hello, good night. Could you tell me which ones without the measurements of the internal and external diameter as well as the thickness of the tippmann tmc rear bolt bumper pls
It's generally the same thing for the elite, except for the "L" shaped gas line going to the stock instead of the slightly bent line going thru the grip. U can see the groove for it when it's apart in this video. Prettt simple
@@jeff.910 on the left side of the gun there’s a hole you can put a Allen key into it and change the fps (the hole is near the “TIPPMANNSPORTS” letters)
ANSgearPaintball So at the bottom of the ASA is a tiny hole on the TMC and everytime I hook up my air direct and also through a remote line air leaks out of that tiny hole. What do you think the problem is? And is it like an easy O ring fix?
It could be a couple things. Try replacing the O-ring of the tank and the remote line, (whichever part is being screwed into the asa). If the problem persists, then it could be the asa. They have been known to be incorrectly machined occasionally on that particular gun. If the problem persists after you've changed the o-rings, then contact Tippmann and tell them what's happening and they'll be able to set you up with a new asa if that's the issue.
what are the springs made of? ie stainless? or spring? will they rust... if i have a bunch of balls blow up in the mag can i soak it in hot water and then let it dry and re lube the mag and spring?
its milspec but there are two groves on the sides of it about 2 inches long on the receiver side so if you change the stock you wont be able to collapse it all the way in, if you are tall like me it works fine :) hope this helps
my tippman has a issue where the trigger "stalls" as in when i fire if i aim my gun down it wont engage again or refire unless i switch the safety off and back on or give it the "soda machine love tap" then it will got any reccomendations on how to fix it?
What do I do if my tmc keeps fucking up like for some reason when I use the hopper fed it jams and I have to pull it back to get the co2 back in it and it happens from time to time
