You tie a 260/modeling balloon to it and use that to wrap it in. I usually roll the valve up around the middle of 260, tape it, then tie the 260 in a knot around the valve for extra string hold. Then I wrap that into a small 5” quad and then tie that quad into the garland with another 260.
Yes cuz l can’t get it to go in they’re making it look easy where my valve is blocked. I be tried putting it over & under the space even with a straw it’s sealed.
Great advice, but you don’t need to seal it. I’ve had foil balloons numbers, letters, characters 16 to 40 inch for a whole year, and still going strong.
Mine isn’t working or I’m not doing it properly, where the valve is it doesn’t go in all the way there a sealed tight closure am l supposed to puncture it?
Did u get it? Because I have to put a straw in the foil balloons and put the extra valve upside down in the inflator and hold it because it doesn't screw because it's upside down and then it blows up
This balloon needs to be inflated until all the wrinkles are gone ! The balloon is an sphere after inflated. Like the Orbz balloons from Anagram. The balloon is not gonna pop. Keep going until you get the perfect sphere shape. They look marvelous in garlands or filled with helium !!!
Just learn this myself I there's quite a few people that don't know .I was sure it was gonna pop, but it didn't. I used the electric pump and then used my hand pump to finish to make sure it didn't pop little by little and slowly.❤
Yes, I had some that poped very far from getting the sphere shape. But lots of them that didn't. Allways talking about chinesse one or unbranded ones. It is good tip going little by little with a hand pump 😊 !! I also use this tip in some balloons that I haven't tested yet !
How you gonna have a video about how to blow up a balloon when you’re not inflating them all the way? Orbz you’re supposed to inflate until the wrinkles are mostly gone from the creases so that they’re circles, not squares like these.