TOPAZ: FINDING THE CLEAVAGE

Подписаться 4,5 тыс.

Просмотров 1,4 тыс.

50% 1

Detailed video about "what is cleavage?" and finding the cleavage plane in topaz gem faceting rough.
Check out our other videos about topaz faceting rough:
Topaz: Cleavage Nerd-out
• TOPAZ: CLEAVAGE NERD-OUT
Topaz: Cleavage vs Fractures
• TOPAZ: CLEAVAGE v FRAC...
Topaz: Cleavage & Alignment for Zoning & Direction
tinyurl.com/to...

Опубликовано:

16 окт 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 11

@justinmynatt896 7 месяцев назад

This is phenomenal information. Another great tool to add to the tool box! I'm pulling out all my river worn topaz rough right now to check it out. Thanks John!

@Kpat101 2 месяца назад

Great video and good explanation . Thank you.

@hillfamilyfarms1962 7 месяцев назад

This is why I quit cutting topaz. Thank you for a great explanation. You showed a good number of examples that made it easy to finally get it. Presented perfectly!!

@TechWookie 7 месяцев назад

Great video, very informative thanks!

@susanncarter6201 7 месяцев назад

That was very good information, thank you very much. I’m doing Gem ID and keep these coming.!

@lisascenic 5 месяцев назад

Thank you for this demonstration.

@worlderrorcoins 7 месяцев назад

Hi, thanks

@jimbutcher9277 7 месяцев назад

Thank you.

@jimbutcher9277 7 месяцев назад

John, are there any videos on mounting the Facetron in your workbench? I notice in some of your videos that the facetron you use is mounted in your workbench.

@gemstoneartist 7 месяцев назад

The machine on my workbench is actually just sitting on the countertop. It's not anchored down, but held in place by its own weight. Never any issues with this, and it's easy to lift out and put back on the base. I don't think this requires a video, but I would share two comments: 1. Make sure the deck of your machine isn't epoxied to the wooden base. They did that for a while and if it's glued-down, it's going to be a headache - and probably require destroying the wooden base - to get it lose. 2. Measure the INSIDE of the wooden base to get dimensions for your hole. Measure twice and cut only once ... Hope this helps.

@jimbutcher9277 7 месяцев назад

John, thank you it does. I appreciate the response.