Toyota Tundra (3rd Gen) Rigid Industries Rock Light Install - How to tie into courtesy light circuit 

Alright I got it done. Previously I had installed some footwell lighting and I had tied it into the same power source you did. I ran wires from the end of those footwell lights to the rock lights. I drilled holes same as you did and ran the wires through a loom behind the dashboard to get to passenger side. Except for using self tapping screws and drilling holes I did not have to go outside the cab of the truck. The one thing I did do was to put a small bead of silicone on the bottom of each light so water could not get inside the truck. Just another way to skin a cat.

Just got doing mine, turned out the same 👍 I am doing a little something extra though. Found a way to make them switchable as well. I'm about to do it tomorrow. Run an additional ground wire spliced into the splice you did for the floor light ground, and run it to the chassis somewhere (easy to find). The key is, you need to run this additional ground through a circuit breaker. Keep the circuit on, lights on demand. Break the circuit, lights will only come on with the courtesy/door ajar etc.

Great edit. Glad you like the Rock lights!

I am looking for a video about adding fog lights to a 2014 tundra that does not have any fog lights at all. I can find tons of them about changing to a dif type/make etc. Have you any videos showing the complete and total adding of fog lights?

@Fkakapain, did you ever find a solution? I have the same issue on my 3rd gen with the MicTuning C2 lights. I think its the bluetooth module but i cant find a harness to bypass it. I need one similar to the one Anderson shows in the video but for the MicTuning kit.

Weather turned to crap and we got buried in snow. Can’t get into my shop because all our equipment is in there. One question. Did you drill up through one of those holes after pulling out the plug or did you just guesstimate, drill a hole through the top and then fish it through the hole where the plug was? Thanks.

Thanks for the video. Is it possible to turn these leds on while driving? I flipped the dome switch on but it only turned the dome/map lights on.

I installed opt7 running board lights and tapped into the blue wire of the footwell light and ground to bare metal and the lights stay on but will not turn off. Do I need to tap into the tan/ brown wire for the lights to turn off?

Nice job. Seems a little complicated. Could you have run it under the dash?

Forgot to mention, this works on 2nd gen Tundras too