TPA3116D2 Hifi Stereo Amplifier (50+50) Watt (XH-M562) Review and Testing Urdu/Hindi - Tech Therapy 

Thanks

Tpa 3118 dear

Thanks 😊

Yes you can drive this speaker because of 3ohm impedance use - 12-15 volts. If on full volume you can't get noise sound you can raise the voltage to 19 volts. But if sounds become noise you may use low voltage 12 volts

Okay, thank you. May you always be given health and hopefully your channel will continue to grow. greetings from 🇲🇨 indonesia

Thanks dear❤️

Bhai TPA 3116 50 + 50 watt ka amplifier ha is me is se zyada output nai a sakti unless k ap bridge mode me amplifier use na Karo to Jo market me 120 + 120 ha wo darasal 50 + 50 hi ha us ka gain zyada ha or baki sub same ha ap wo le lo

Tpa3118 is the best amplifier you may use two amplifier and make it stereo.

Sound vise same but it has more watts. For getting more power increase the input voltage

Bhai tpa3118 mono 60 watt ka ha to AP ager 2 amplifier ko stereo bnaen gy to 60+60 (120) watt hon gy or ager ap tpa3116 use krty Han to 50+50 (100)watt hon gy to better ye ha k ap tpa3118 use kr Len ager ap k pass itni jaga ha to nai to tpa3116 amplifier b bohat acha ha sound quality dono ki same ha.

Thanks brother agr donon ki sound. Quality aik jaisi hai tu phr main tpa3118 ka he amp buy kron ga . pr ye kahan sy mly ga ? Reply

Brother ma ne to AliExpress se mangwaya ha link description me dia ha ap link open kr k check kren.

Aap ko kis price mein mla tha aur kon sa wala

Around 350 rupees both price same tpa3118 n tpa3116

Maximum 24 volt 5 amp

Kitny watt ka woofer chalana ha ?

@@techtherapy296 120watt fredo

Impedance kya ha un ki ?

120w rms, 4ohm

Depend what you give supply voltage.

I m using 19 volt with 5 amps

@@techtherapy296 I have 4" 4ohms 50 watts. how many speaker connect with on each channel

@@mananlad7738 Depends on you how many speaker you want to use in each side just keep in mind total impedance is 4 ohm not more then or not less then you can get maximum output from this amplifier if you use 2 ohm impedance speakers / woofer it can burn ic in few minutes or if you use more then 4 ohm impedance your output watt is decreasing. ( I Connect 4 mid woofers with total 4 ohm impedance and it work fine on each channel). Hope you got my point.

Please tell me in English or Urdu dear

@@techtherapy296 brother this amp sound is very sharp can we make something to sound of this amp soft. Sharp sound to soft . Is this possible and if yes how ??

@@bossofhind7900 brother what do mean my sharp? please explain me. Thanks

@@techtherapy296 brother I am asking you about amp. How to amplifier sound to convert to sharp to sort .

@@bossofhind7900 dear you need a filter to smooth the output you can control from your mobile equalizer or by your input device if not available that option then you will need pre amplifier with filter control circuit, for now I don't have such a filter circuit or module in future maybe.

Laga sakty han is ko heat sink laga lena ap chota sa

@@techtherapy296 aare bhai hum tpa3116 d2 50+50w ka filter wala lagaya tha full volume karne par awaj hi nahi aata tha

Kitny volts pe

@@techtherapy296 22v

Us board me issues na ho Bhai bord change kr k daikhen kyun k is amplifier ka gain avha ha input pe Kya lagaya tha ?

Yes dear

@@techtherapy296 this board is better or tpa3118 ( www.ebay.com/itm/363404161217?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2060353.m2749.l2649 ) ?

Tpa3118 is a 60 watt mono amplifier and tpa3116 is 50+50 stereo amplifier

@@techtherapy296 yes, but I have 2x35w (8ohm ) speakers and for this I need good sound and IDK which is better 2x this 3118 board ( for left and right channel) or this board what u have, if u know please tell me

Tpa3118 is good for you bec it's have high gain and your speaker impedance is 8 ohm. Use 21 -24 volts for better sound add little heatsink.

Link updated

link send karo or kitny ka liya ta

Description me check kren

Link is not working.

Tpa 3118 is better because it have output filter

Tpa3118 is better because it's have output filter

@@techtherapy296 bro which is much louder toa 3116 this one or 3118

@@techtherapy296 xcluma xh-m189 2 * 50w digital amplifier board dc 24v tpa3116d2 two-channel stereo bro i have found this on Amazon bro is it is better than tpa3118 . it is 50+59 sterio amplifier and it has also coil plz reply is it is better than tpa 3118

Efficiency wise both is same

Ok i will update

Purchase from Local market box also locally made dear

Bhai link me mentioned ha ap link open kren price pata chal Jaye gi.

@@techtherapy296 Link me kuch alag hi open ho raha hai

Add a heatsink on the chip

Zaroori nai ha bhary heatsink ki per ap is PE chota heat sink lag Len

@@techtherapy296 bada heat sink better hai, agar 10-20w se better o/p chahiye toh. agar 20% loss se hisab karein to deat sink 4-5w diisipate karke v thoda bahaut cool rehna chahiye.

@@iceberg789 g AP wahan PE chota heatsink laga Len Jo wahan pora a Jaye kyun k ic ki side PE Jo capacitor Han wo bhary Han

@@techtherapy296 i see, thanks.

Ask me😊 what you want to know ?