Hi there! Yes you can but you will need to configure the TM3BCEIP using the standalone software and the webserver then read/write the data using the M340 . You can use the blocks or the IOscanner. If you are using ModbusTcp in the TM3BC software you will see the addresses.
Hi LeTomas, can you help me with M221? What i need is : M221 i need to take values from 2 different Devices on the same IP-address with different Device ID and then i need the M221 to be as a slave Device
HI there! having two physical devices with the same ip address with cause a ip address conflict in your network. I will not advice to have that configured. What is possible is to have configured on the Ioscanner the same device ip address but different UnitID as i did with the TeSys Island explanation: ru-vid.com/video/%D0%B2%D0%B8%D0%B4%D0%B5%D0%BE-Kyikd14jNBY.html
How can we add a TM2 series module to the TM3BCEIP ? In guide of the TM3BCEIP there is information that this is possible, but in TM3BC IO Configurator that it isn't possible. Could you give saome advice about that ? Thank You.
Hi Jacek! thank you for your question. I found out that in the application "TM3BC IO Configurator" it only allows you to use the TM3 module. However, If you use the software for the Modicon M221 or the EcoStruxure Machine Expert in the configuration of the Bus Coupler it allows you to add the TM2 modules.
@@LeTomasAHUMADA Due to lack of TM3 modules I need to try TM2 😁. Thank you for your hard work and sharing videos, this is a huge part of practical knowledge.
when we use TM3TM3/G module ,the status of I/0 modules readed from address 930 size (words) 3, but why we used address 900 for the status of Bus coupler and where I can get the address of bus coupler from "TM3BC IO Configurator" (I can't find it)?
