Switch languages with RU-vid Auto-translate.
With this command, you can finish a day's work in half a day!
I tried to collect tricky commands that can be used immediately at work.
* For those who have some basics.
↓ Click here to purchase from the Autodesk official website ↓
bit.ly/35srHuW
Support me through my affiliate link
【basic operation】
Enlarge → Rotate mouse wheel up
Shrink → rotate mouse wheel down
When you want to cancel the operation → "ESC" key
When you want to restore → "ctrl + Z" key
0:33 Part 1 "I want to specify two points and take the center" (midpoint between two points)
3:12 Part 2 "I want to put together the disjointed lines" (combination-1) *
3:53 Part 3 "I want to pinpoint only the points I want" (priority object snap)
5:33 Part 4 "I want to position without auxiliary lines" (base point setting)
8:23 Part 5 "I want to divide the line into two" (partially deleted at one point)
9:59 Part 6 "I want to use the same layer, line type, and line color as the selected figure" (property copy)
12:27 Part 7 "Stretch" (I want to move the fittings with the wall)
14:41 Part 8 "I want to display only the layer on which the selected figure is drawn" (layer selection display)
17:20 Part 9 "I want to preview each layer" (viewing layers)
18:24 Part 10 "I want to specify the size and content and select characters and figures at once"
(Quick selection and character search) *
※caution※
-The figure of "Join-1" must be connected to the end points. It is not possible to combine shapes that are not connected. However, in the case of "Join-2", if the two lines are on the same straight line, they can be stretched and joined even if there is a gap.
-To display the search results of "Character Search", check "Show Search Results" in the "Search and Replace" dialog box.
20 май 2020