turn signal won't blink/flash fixed 

It is possible that the relay needs replaced. Is the battery fully charged? I would try supplying power to the bulbs directly to see if they are defective. You could also take a reading from the wire at the connector to make sure power is being sent to the bulb. Hope this helps.

@romeparrilla8307 This was the same issue I was experiencing.

And the other 3 are working fine, and its not thr bulbs because i tried eith more lights

If I recall, mine were just not flashing. They were not all on at once.

Try replacing the one that doesent flash ​@@karlokovacevic8548

Will the lights come on if you fed dire power to them? If the bulbs are good, it'd check the switch a s the relay.

@randomprojects1671 the front two will stay on, however the front left blinkers won't work only right side.

@randomprojects1671 I'm stuck between just replacing the rear blinkers. And seeing if it's a circuit breaker issue. I have a circuit breaker on the way rn and if that doesn't resolve it. Ima replace the rear blinker lights any

Have you tried changing the lights themselves? Or are you not willing to change to aftermarket?

@@randomprojects1671 they were after market LEDs that the previous owner installed. I found out the issue the last owner like a dingus he is wired the left turn signal wired to the license plate light 😂

@maxa6082 I would correct that if you're able to. The wiring for the plate is not meant to blink or connected to a relay that does.

@@randomprojects1671 I did the connections are all correct now and the stock relay is installed, the Amazon relay I bought has been returned and now my bike is working perfectly 👍