[TUTORIAL] How to power up your Nerf Modulus Stryfe in 4 mins / easy voltage modification 

blastaway.eu If I used 2 IMR batteries, and two dummy batteries, will my motor burn or not ? AndI also can I use ANY BRAND of Imr batteries that is 3.7v ?

Initial VAT if you just use 2 IMRs, you are safe! the brand doesn‘t matter, but you need a special charger. i also made a tutorial on how to make dummy batteries...

blastaway.eu i

blastaway.eu koo

Initial VAT i found li-po batterys on amazon $14 4, that seem like these, do you think they’ll work? Eventually im going to rewire the whole thing and swap the motors (its just way too expensive right now its a hobby... lmao if i rewired the whole thing id have to spend about $80-100 on all the stuff, i need a new soldering iron, wire etc...) If i do break it is there a video i can watch on how to solder it or is it straight forward?

@Casper Meijer I don't think it can take a LOT past three volts before it becomes unstable..

are you just able to twist the yellow piece on the thermistor to bypass the problem of using 2 IMRs?

Wait, does this include the modulus demolisher as well?

Where can I find these batteries?

How many volts are each of the batteries

blastaway.eu Would this work with Ultrafires?

That is dangerous you need to rewire it with a higher gauge wires so that the wires do not burn up and replace the switch that's a must do please do not listen this is very dangerous to do rewire strife or any other electronic blaster before youput upgraded batteries in it

Omar Aventador yes

Dan Botich higher gauge wire is not necessary unless you use even higher power sources. rewiring is mainly done to raise performance. the more stock wiring you have the less power will reach the motors. dangerous might be improper use of battery sources. your blaster or parts of it won't "explode" - you don't seem to know enough about electronics to give qualified suggestions - no offense!

blastaway.eu Thanks!

cool! thx for the feedback ^^

+blastaway.eu where do I buy IMR batteries and the charger for them?

@@salt4318 amazon

Rewire?

+christopher kelley My orange Stryfe XD actually did. I live in the US though.

Yeah I do to but I guess it's just some d o some dont

+Lamar Golson WHAT THE FUCK. My Stryfe came in orange, and I thought it wasn't XD. SO I HAVE A STRYFE XD?!?!?!?! OH HELL YEAH

Christopher Kelley so that mean you can just put the batteries in?

Chris Kross my orange one had a dart lock, but idk if it's a difference but my Orange stryfe doesn't have an "elite" text on the white paint job like most of them do, does that have anything to do with it?

i did the same what you did on my orange stryfe! ^_~

bigemugamer same with my oj stryfe

Damn, you're right, why'd they do that with the orange stryfe anyway?

I found out later on the dart lock was removed because damaged darts would potentially not load properly.

Can you just use a regular twist tie to tie the legs of the resistor together? Because I am not positive as to what you mean by saying "metal part of the twist tie" because, I have only ever seen plastic ones, so I am a tad confused.

Yes, you will eventually have to rewire and upgrade

@@AleksandarGoleminov how long till you have to rewire?

@@somechickensquid3916 In my opinion if you only use 2 IMR batteries (any brand) and 2 dummy batteries I think it'll last longer than using 3 IMR's and one dummy. So maybe like in at least 7 months you can rewire.

@@antoinepumicpic3616 ok thx

@@antoinepumicpic3616 when I got the oj stryfe for Christmas I was happy, I’ve ordered some attachments online of which a 22 round worker mag is included would that make the stryfe burn out because I did it with a 25 drum and it did, so I was wondering if I opened the stryfe and bypassed the thermistor, would that have any impact on the blasters performance/life?

So, how did It turn out...???!!!

@@JupiterKnight lmao

But how did it turn out?

@@marsh499 hehe

Bruh

@@Namanoh Oh, didn't know that they were that dangerous- Thank you for letting me know about that, I'll not be looking for any type of IMR's anymore

@@Namanoh Hm

Probably out of darts or ebay

Does it depend on the stryfe

@@crayzshh168 No.

I second this.

F/A-18F Super Hornet k

Saberwing 7 THANK YOU, YOU ARE THE ONLY OTHER PERSON IN THE COMMENTS THAT IS EDUCATED

Yes four IMR will burn the micro swiches and possibly the motors to

@Brandon Cho I know lol

@Brandon Cho So doing the exact thing did in the video with 2 imrs and dummies would do? Without having to replace the motor?

@@user-yb7ik6sb1v it will be less powerful then 3 imr's i think youll still have to do the steps inside with the thermistor not sure tho

@@Octavio-mk5mv where and whatcha imrs should I buy?

As long the IMRs aren’t long term(you switch to Lipos and upgrade the motors) the thing is fine.

@@justanotherasian4395 what sort of imr battery is that? Will a 1.2V work?

@@mee8915 1 IMR is also known as 1S (1 cell), and are 3.7v. You can run 2S Lipo batteries (or 2 IMRS, 7.4v) and doing the steps in the video to bypass the thermistor, without rewiring or upgrading the motors, and it will run well for years. 3S batteries (11.1v), will work, but with the stock wires and motors. they can spark and burn, if not immediately, in a few weeks of use. If you're planning to mod past 2S or 7.4V, then you need to rewire with thicker wires, better rev switch, and better motors, the last of which will cost more than the battery itself depending on your location. 1.2v is equivalent to 1 *rechargeable* AA battery, while the *stock* stryfe with no mods runs at 4.8v or 6v if you run it with non-rechargeables.

Where did you get the battiers from I have looked every where and still have not found them plz tell me

What sort of imr battery is that? Is it 1.2V?

Thanks dude

Does 2 work fine without having to twist that wire? And how’s your gun so far?

please check out my other tutorials as well ^_~

+Mattsoup thx for the feedback ^^

Da fug this spelling?

Lucid_That Big Boi i'm not english!

JK I have good spelling.

+Jared Olsen you're welcome

@@blastawayeu Do I need LMR(lithium manganese) or will LCR batteries work?

Anju if you are still wondering imr will be far better as icr are much less safe and have been known to explode in a fiery mess and imr will probably yield better performance but please please please do your research as these batteries can be very dangerous

+Le On thx! here's the "follow-up video" ru-vid.com/video/%D0%B2%D0%B8%D0%B4%D0%B5%D0%BE--fM0on1aU-E.html ^^

Lightningstrike 273 no 14500

ok thanks

Can we use efest imr 18500 Li-Mn battrey 1100mah 3.7V?

18500 anything, is way too big for the stock battery tray to use.

Imr rechargeable is redundant one two hell no

+nick kopschaninow lol what? first of all, he's using 3 IMR's and that is completely fine, only 4 will hurt the motors. Next of all 4 months? A stryfe with IMR's lasts way more than that and lasts the same as a normal blaster. Also a normal blaster lasts twice as much as 6 months? dude, blasters last more than a year. I have a perfectly fine modified maverick from 7-8 years ago, what the hell do you do to your blasters to destroy them that quick.

+nick kopschaninow here's proof, that you'll be fine doing this mod ru-vid.com/video/%D0%B2%D0%B8%D0%B4%D0%B5%D0%BE-eOkNUuPltTs.html

he’s honestly not lying I did this to my desolator and it burnt out after 1 year

funfacegaming wrong gun maybe?

so just to clarify, that stryfe coop was using had these mods and no rewire?

+Jason Dato efest

what happened after?

@@jesusdavidromeroventura3482 I think he broke it

U mean stripped the screw?

+Excalibur 4249 yes that means stripped the screw

+LamsterLou ah I see sry +Tyrone there is a special screwdriver used for stripped screws if u go to the local homedepot and ask if they have anything for stripped screws they should get you something for a decent price

Excalibur 4249 Thanks :)

+Tyrone no prob dude/dudette:)

They wouldn't work they would run so fast that that would blow out your motors in an instant, let alone the government of any country freely selling Nuclear material to the public

+nick kopschaninow Exactly

are you high?

dude im from 3 years after this and take my word. The stryfe will be the new hiroshima bomb.

It would last decades

I know this comment is from 2 years ago but where can i purchase trustfires?

@@jonathanwoo1533 Sorry to let you down mate, I moved to Airsoft years ago.

yes

Or RUR'U'R'FR2U'R'U'RUR'F'

NEGATIVE 3

i think so... not too sure, which ones you are comparing ^^'

blastaway.eu well, I'm from Guatemala... So, it's difficult for me to find those kind of batteries. And I don't know so much about them... Which would you recomend me? I'll look for them here ^-^

3,7v, 700mah

Thank You!

so its the 14500's ?

do they look like Aa or C?

Josh Pickering AA

Parker McCarthy if you were homeless, you wouldn't be able to type a comment dumbass.

Nerf Justice So you're saying he lives in a computer

HAAAAA!

I'm sorry for ur loss

You must have done something wrong.lol

for the rayven it's the same principle! as long as you don't retwist the thermistor, there's no harm in trying!

Sounds great! Thanks for the vids and keep 'em coming!

20 is a goood price lol

Andrew Bonville i think so

Jacob C this video does it all

it should work for sure... only the difference in performance might not be there... ^^'

If you are going to buy imr batteries promise me you are going to do your research on safety and have a general understanding of electronics. “Out of darts” is a modder who has a online shop that is trusted by everyone and has everything you will ever need for modding including imr batteries and the proper chargers

+yolo life thx for the feedback ^^

It is worth noting that 3 IMR batteries will kill the motors faster than 2. If you want longevity I recommend using better 6v motors and running it on alkalines or nimh AA cells

@@paulyd4978 which batteries exactly?

efest

Nick 262 Amazon.

irwan HUZEN well, next time ^_~ although, the demolisher does not need any rewiring to run upgrade batteries...

blastaway.eu Thats what i would do...

Si la ligas me jor

Inactive well, first of all it's about the big difference in performance. then, if you start worrying about the best/max performance you don't need a tutorial from me. my stuff is aimed at beginners... but thx for the input! ^^

blastaway.eu so it dont burn the motor or do someting to it right ? cause i dont want to break my stryfe

if u have 4 imr batteries wit will burn out but 3 is fine

readyeddy using 4 regular AA batterries will probably never burn out your motors. there´s always a chance of breaking something, even if you don't open your gun... but it hasn't happened to me

i almost never use better motors... you have other channels which show that....