ULTIMATE RAZOR SUPER MOTO Revealed! Part 1 - Mini Series  

Wanna build your own mini moto? Visit voltronwatts.com to get started! 🤜🤛

The wire from QS was probably tinned copper, it has better corrosion properties after being tinned from wet or dirty environments.

when sizing your chain first push the rear tire all the way forward then install your master then slide the tire back to the proper tension. you started in the middle which will likely result in a link removal later to compensate for any stretch and wear

Sick can’t wait to see the other build videos 🤟

Masterlink clip was installed backwards. You want the closed end facing direction of chain travel. If it gets snagged on anything as it is it could pop the clip off.

Can't wait for part 2 !

looks so good bro

What guage wire is recommended for upgrading the phase wires? I presume it partially depends on current going through them...

ur amazing only video in depth about stretching phase wire thanks your such a help

QS165 motor shaft has a right hand thread for the nut which means that you have to put motor sprocket to the left side for the nut not to be unscrewed when motor turns. And of course the wheel large sprocket must be on the left side too. The original motor for Razor Super moto ( kunraj MY1020 ) has left hand thread. Probably that's why you just put QS165 there replacing the old motor, But make sure the nut not be unscrewed during ride.

How are you liking the royce ramirez swingarm? Have you hit any jumps with it and if so did it hold up fine. Thanks

which platform should i use for my first razor build? i want to build a super moto style like yours is it the mx500 you would recommend? sx?? love ur content brother

Where did u get the tires from? The bike?

What color paint is the frame?

Where did you the the tires from?? Look sick! Would like to get a set. Love the channel kept them coming.

what is the max power and rpm we can get out of this motor

Swing arm?

Holy battery

great

Where did you get the wire cover