Does that mean. Moving the LSNeedle clockwise/forwards into the hole is restricting fuel flow therefore allowing more air, resulting in higher revs, bogging and a far hotter engine?
I always when getting a second hand nitro flush needles then I know I'm rich then just tune in abit to get that sweet spot once ya get ya head round it it's not that hard. ❤
Not sure if this is the same issue I’m having. Same engine .25 on Kyosho. It’s basically new but The idle seems to rev up and down then will shut off if I’m not giving it gas. Any suggestions?
Question just got my revo 3.3 out now when running it has a gurgling.Right now my high side about 2 turns out my low side I get 3 seconds and it dies out on the pinch test
I don't know i tried all kinds of ways here after running for 10-15 minutes runs good the when i go the pull full throttle it just boggs down and sounds like it.going to shut off.Its a 3.3 hsn 3-1/2 out low 1-1/2 out.