Very Important Steps to Correctly Install a Stern Transducer - OOW Outdoors

Подписаться 24 тыс.

Просмотров 45 тыс.

50% 1

Be sure to follow the these steps. They are very important steps to properly install a transducer from Humminbird, Garmin, Lowrance or Ray Marine. This will keep the Gps Calculations correct.
Please Subscribe, Comment, like and Share our videos.
**********As an Amazon Associate I earn from qualifying purchases. #CommissionsEarned
Must Have Essential items:
Pliers Multi-tool LeatherMen WingMan : amzn.to/3r5UYmE
Bug Repellent Coleman 100 Max: amzn.to/3cnTGPz
Electrical Tape 3M Super 33: amzn.to/2AWPHWw
Sunglasses from Costa: amzn.to/2IzVuWi
Flashlight - Armytek Tiara C1 (Awesome magnetics rechargeable tough little light) : amzn.to/2Ytvt2s
Best Fishing Line
[Fluorocarbon] Sunline FC Sniper : amzn.to/3aj330m
[Monofilament] Maxima Ultragreen : amzn.to/3aw6jWz
[Best Cheap Monofilament] Zebco Omniflex: amzn.to/3iYWzb3
Here is a detailed list of what I used in this setup:
GoPro HERO 8 BLACK - amzn.to/39uB0Mg
Gopro Hero 9 Black - amzn.to/3tahooI
Amazon Basics Chest Harness - amzn.to/2MB6FCL
OE GoPro Chesty - amzn.to/3achmDY
Saramonic SR-XM1 TRS Omnidirectional MIC - amzn.to/2NDVDNx
GoPro Pro 3.5mm MIC adapter - amzn.to/3cq3HMu
Eboot Furry Outdoor Microphone Windscreen - amzn.to/2L0cusW
Power Bank - amzn.to/3aw5ZXR
90* Bend USB-C Cables - amzn.to/3oqzfUI
Our current "A" Camera Setup:
Camera Gear I used:
Sony A6500 - amzn.to/3cpZzvU
Sigma 16mm F1.4 DN DC - amzn.to/3t99OKT
Sigma 30mm F1.4 DN DC - amzn.to/2L1lXAi
Lighting setup:
Led light : amzn.to/2MEmA34
Parabolic Softbox : amzn.to/3r0WYwr
Follow us for instagram: outofworkoutdoors
Follow us on Facebook: / outofworkoutdoors
#transducer #humminbird #livescope #fishfinder

Спорт

Опубликовано:

17 мар 2021

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 19

@jamesathendune9026 11 месяцев назад

Thank you for your clear explanation. You have given me hope. Going to try again to adjust my HB transducers with the right angle up with level on the water first then duplicate on the lift. Don’t expect miracles but just want the best result.

@homerson1080 3 года назад

Thanks for the tip! Need to remount my transducer

@OutofWORKoutdoors 3 года назад

Happy to help!

@bazbbeeb7226 Год назад

Great video, very clear instructions. Thanks from Ireland.

@AS-pq3hu Год назад

You are one of very few people who knows what he is doing, Thnx

@officialWWM 4 месяца назад

Except, he doesn’t.

@VKOutdoors 3 года назад

Awesome video. I’m putting in a garmin 73sv with a gt54 transducer. I was going to wing it but glad I didn’t. I did not know about the leveling. Thanks

@OutofWORKoutdoors 3 года назад

Glad I could help!

@1moparmadman 3 года назад

Unless it's really new, there's usually a water line that shows on the boat. I use that angle to set my transducer with, and it's always pretty darn close.

@OutofWORKoutdoors 3 года назад

great tip!!!

@leewellman3369 Год назад

You also have to account for trim on the motor at full speed lay a straight edge of the bottom of the boat and allow the but end to touch the front of the transducer should hit at the fold line on the transducers usually about the half way mark

@CapnDanTreasures 5 месяцев назад

The BOTTOM of the Transducer only needs to be an 1/8" below the surface of the bottom of the boat on a fiberglass boat, and 3/8" below the surface of the bottom of the boat on an Aluminum boat.

@ronniegauci3843 Год назад

what happens when you and your gear gets loaded into the boat, does that not put the transducer off?

@OutofWORKoutdoors Год назад

You have to just do an average of which is most likely the equipment weight you will have and angle to that

@FreshwaterSouL 9 месяцев назад

I had a full tank of fuel and all tackle in the boat with all the batteries and did my settings for the transducer

@officialWWM 4 месяца назад

You’re wrong about the transducer angle. It should actually point downwards at the rear, not upwards! That is the secret to getting it to read depth correctly at speed! You will never get clear high speed readings with it pointing upwards like that!