Vex High Stakes Intake v2  

since we do screw joints, having the c channels [ [ ] ] we can put the keps nut hidden inside the c channel so that we save space, the other side is that direction because it saves space when mounting the motor and gives more access to holes when building on the drive

We were running about 325 rpm on a 24t sprocket

@@Choso143 isnt that a bit too fast? i tried that and my rings are flying out

That’s why we have sails on our robot, it stops the rings from flying out

@@1138B-NotAdi ohh makes sense

better flip

Nothing is sped up

@@1138B-NotAdi even the sounds didn't make sense unless it was sped up. If its not sped up at all i would love to see it perform at clash in the canyon

@@tenmo5690 its currently lower that this video because it didnt go under the ladder, it isnt that hard to make a intake fast. I think you just need to cope

@@tenmo5690 watch newer videos lol, its even faster now. can you match my freak?

blue 600 rpm

The lower one

@@1138B-NotAdi thank you 🙏

Or are those zip ties?

@@673GRiptide zipties

@@1138B-NotAdi oh alr

On this bot we half cut our 72 tooth gears so that they fit in a 3 hole gap, the 72tooth gears have a steel core which is hard to cut through so we didn’t cut through it. Because of that the only way you can do 3 hole gap is with putting the gears on the outside. Ryan Liao(vex build quality god) did this for this spin up worlds bot

@@1138B-NotAdi makes sense I will most likely never do this in my vex career but if I have the time maybe

@@huhrawz ok dad

@@1138B-NotAdi good boy 💗

avid chase fan

@@1138B-NotAdi yep