Volvo XC60(2017) Rear Brake Pads with Electronic Parking Brake

Подписаться 242

Просмотров 12 тыс.

50% 1

Always safety first, jack on cement and use jackstands, I also slide tire under frame for extra protection. Also I need to add some text on video, I said counterclockwise to turn electronic parking brake I meant clockwise to be able to push piston in, then back only a few a turn or you will push piston out. Sorry for poor video quality. Sun was horrible and couldn’t see much on screen. Any question about electronic parking brake, please ask. You can do this job without an expensive scanner. Tools required.
Floor Jack
Jack stands
19mm deep socket for wheel lugs(first loosen some before jacking unless using air tools.
13 mm socket caliper pin bolts
15mm (narrow) end wrench to hold pin
T-30 electronic parking brake actuator
T-40 to turn actuator so piston can move
C clamp
Screwdriver flat head to remove caliper and pads

Опубликовано:

9 сен 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 11

@edmundaszlk649 Год назад

Good video. I used a 12V battery, it's very easy and saves time. On passengers side front pin is negative, on drivers side front pin is positive. After I've done one side, started an engine and turned on few times parking brake the message "parking brake not fully releasing", so when I finished both sides and repeated everything was OK, the message disappeared. Thank you.

@rltkktlr Год назад

Great work edmundaszlk!

@J0hnny0 5 месяцев назад

I used a 9v battery to retract the brake piston. very easy and beats taking the EPB apart.

@edcarter2295 Год назад

Thanks for this video! You show exactly what I needed, I had heard it was possible. I didn't want to use the 9v battery method to run the pistons back. You can buy a Volvo parts kit with the O ring seal & two new T30 bolts but its ridiculously expensive (about £20 per side) for what it is.

@rltkktlr Год назад

Glad it helped you.

@alexmclaughlin7894 11 месяцев назад

This was so much easier that removing the electronic brake in my opinion. Thank you!

@rltkktlr 11 месяцев назад

I agree! Great minds think a like! Glad it helped you.

@seanporter9311 9 месяцев назад

Is it me or can you just turn the car engine off and not engage the hand brake but leave the car in gear to not need to do all this with the electronic handbrake. This method leaves the handbrake off.

@fredflintstone2077 7 месяцев назад

Only if you are going to refit the old brake pads. New pads are much thicker so the handbrake mech has to wound in to allow the thicker pads to fit in.

@rltkktlr Год назад

Hi Ed glad it helped you out. Let me know if you have any other questions. Thanks for watching.

@malcom59 Год назад

I just complete a rear brake pad and rotor replacement on a 2019 XC40, the battery thing meh is too hard to tell which way the piston is turning let alone trying to make contact with the two pins inside the connector. So I ended up removing the motor and winding them back manually. I will say buying the tool to wind back the piston for this would have made the job much less time consuming. And when i get to the point of doing this again. I’ll spend the $30 for a cheap one on Amazon.