For any questions you can contact me: eugen.scobioala@gmail.com / eugen.scobioala Download the Manual HERE: www.manualslib... Music: "Breaking Away The Ground" by Valery Stepanov All Rights Reserved to Valery Stepanov
Hey thanks a bunch - that really helped a lot! Tube trimming in progress. Can't wait to hear the difference between 12AX and 12AY. Greetings from Germany, T.
I just mine in from Japan yesterday. What lights up the display, (bulbs,led's,fiber opt's) and is there any adjustments? Tried using it outside & couldn't see a dang thing! Happy so far though.
Dear friend greetings from Brazil. First of all thanks for the videos. Could you help me with a question? I have a VoxTonelab if after a hard reset the amplifier simulations stopped working. Could it be the valve?
I just open mine to put the spur in place of the switch 1 cause it had issues and when i put it all together the lamp and the screen where only powered and the screen had only the backlight. Any help with this?
Hey man, can u help with a thing on my tonelab ? The modulation driver sometimes (like a few in a day) turns on randomly. Do u have any idea whats the cause ?
What is the sign the tube is going bad? Decreased signal output? I ask as mine, while playing, the volume/signal output faded out. It's still there but very low and poor quality. It did this previously but then would begin operating normally.
So I recently acquired one of these, everything cuts on and the face display, buttons, and knobs all function. However, no sound at all unless it's bypassed or on the tuner function. Any thoughts?
while there is the volume knob on the back side where you plug in your guitar, there are volume settings that can be accessed with the knobs in the middle of the board. Have you tried doing a factory reset with the pedal board? Look up the buttons to push for a factory reset. If that doesn't fix it then it could be the tube.
@@OfAbstract If it was jostled or dropped the tube may have come loose in the socket. Or it could just be the tube is bad as you say. I have one and it is noisy and the 1st switch for effect 1 is bad. Gonna have to crack it open soon.
its weak side are its flympsy buttons. I change the damaged buttons every four-six months. It's not so difficult. If you're good enough in soldering, just buy some buttons in internet and install them by hand.
A Scottish motorcycle mechanic once said so wisely: "There's only one way to find out ..." ;-) Jest aside: I just started with the non-adjusted tube and no error message. Starting with the trim program showed a slightly low voltage (as I "sized down" to 12AY7). Just tweak around I suggest! (And report the results).