No video :(

Surprising Duramax Diesel Catch Can Drain After 2000 Miles 3.0

Подписаться 19 тыс.

Просмотров 3,2 тыс.

50% 1

This is in response to my prior video of the initial draining of the catch can. That was after just under 1000 miles and this time around, I ran the engine hard in 110 degree weather across the desert to see just how much oil this catch can would save from my engine ingesting it and burning.
www.duramaxnews.com - 3.0 Duramax Diesel Resource
runvse.com/202...
PPE OIL FILTER: amzn.to/3JP9j22
ACDelco Fuel Filter: amzn.to/3QFfXex
3.0 Duramax Oil Change W/ PPE Oil Filter: amzn.to/3qmLR6o
3.0 Duramax Oil Change W/ ACDELCO: amzn.to/3QtmDO5
Fuel Filter Socket: amzn.to/4b52BkY
Fuel Filter KlickWrench Socket: amzn.to/42arKH6
Aluminum Fuel Filter Cap: amzn.to/3FZir28
K&N Air Filter: amzn.to/3S5sLvq
K&N Intake: amzn.to/4b6oy35
K&N Fuel Filter: amzn.to/4b6Ux3i
www.bankspower.com/demonworks
Banks idash - collabs.shop/b...
Banks iDash Data Monster - 66760
Banks iDash Super Gauge - 66562 (piggyback kit to datamonster)
Banks Pedal Monster Kit - 64311 (piggyback kit to datamonster)
Banks Stealth Pod Single - 63369
Banks Stealth Pod Dual - 63370
Product Link - boostautoparts...
WEIGH SAFE HITCH: www.weigh-safe...
ALSO USE Discount Code DW10 at weigh-safe.com
www.bankspower.com/DemonWorks
www.duramaxnews.com
www.bankspower.com/demonworks
As an Affiliate / Influencer, I earn from qualifying purchases. Your support is appreciated as it helps the channel to continue to test products!

Опубликовано:

25 авг 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 47

@chrisregister510 2 месяца назад

I’m draining mine this week. Have about 3k miles with heavy towing in the heat. Will report back soon.

@user-st4md8bf4o 19 дней назад

Are you still draining it?

@buckwrabbit9276 2 месяца назад

So now you need to take the cooler off and inspect it for oil again. This will prove whether that catch can is doing its job.

@Miguel-fh7bv 2 месяца назад

if that’s true then runvse just made money from our stupidity to buy it ! 😂

@DemonWorks 2 месяца назад

understandable idea, however the stock cooler is in place right now, the ppe charge air cooler removed did have some oil in it. The issue with that is, the charge air cooler was in place before the catch can was installed. So the results will not give what you are after. side note, the outlet from the can is very lightly coated with oil.

@sierracat 2 месяца назад

@@DemonWorksWell, that's not the results that there should be... should be no oil on the outlet side of the can if it's really doing what it's supposed to.

@baldteckguy 2 месяца назад

@@sierracatThat is exactly my thoughts. I think I am going to cancel my catch can after reading oil got through the can.

@sierracat 2 месяца назад

I'm waiting for input/results from others in the real world. Depending on those, I may purchase one but thus far it isn't looking very promising. And it doesn't seem to catch much oil... which makes sense if your not using any or low between oil changes, as no oil is being lost/consumed.

@PastarocketS-sb7nk 2 месяца назад

I ordered mine about a month ago. It hasn't arrived yet. I was told a couple of weeks when I ordered it. 😔

@brianquaderer278 2 месяца назад

Any concern for cold weather issues with one of these catch cans if sitting outside long term then running?

@DemonWorks Месяц назад

Per VSE, no issues.

@traviscrown9189 2 месяца назад

I could be way off here. But it seems that a lot of these upgrades out there. Catch can. Fuel filter. Oil pan. Transmission pan. Rear differential cover. Seems like a high amount of cost for minimal benefit. Maybe I missed something. I’ve been looking at all upgrades for my 1500 at4. But it’s becoming really hard to justify this stuff. Especially once you factor in labor to have them installed.

@Gameplayer70 2 месяца назад

The value is up to you as an individual. I bought everything you mentioned and more, and I’ve had a blast doing all the work myself. I’ve made it my truck and I’m very happy with that. I don’t know if there’s long term value in that, but I never buy upgrades for my vehicle with the intent of getting the money back. That’s a zero sum game, you won’t ever win. End result is I’m happy, and that’s all that matters in life.

@traviscrown9189 2 месяца назад

@@Gameplayer70 I hear you. No disagreement on your position. Trucks are investments and the main factor is cost of ownership. I try to play that out to the best of my ability. I’m trying to get to where you are. Because you are right, happiness is all that matters.

@DemonWorks 2 месяца назад

The reason I buy and test / show pretty much all mods is for this very reason. Not everything is for everyone but if someone is going to spend their money on something, they should know exactly what it is they are getting.

@traviscrown9189 2 месяца назад

@@DemonWorks this is why I follow you. You’re genuine and I appreciated the information you put out. Thank you.

@user-st4md8bf4o 19 дней назад

@@Gameplayer70 You might as well just spend your money on something else that will make you happy, or save it for retirement! LOL

@jonathanw8733 2 месяца назад

Had mine on now for about 1k. So far no issues at all. Gonna let it go for about 7k and check it

@kaylaroberts9817 2 месяца назад

Noticed in the past couple videos you put the stock cooler back instead of the PPE. Just wondering if there was any trouble with the PPE air cooler?

@DemonWorks 2 месяца назад

zero issues, just looking to do more stock related content on the channel.

@jordanmcfarland4810 2 месяца назад

As far as not getting as much oil in the can as Run VSE did, you can see in their video that there is no cross section connecting the hoses. You mentioned this was for a PSI spike or something, but could this be affecting collection vs having two independent hoses?

@jordanmcfarland4810 2 месяца назад

I just installed mine 9k miles 2023 LZ0

@DemonWorks 2 месяца назад

absolutely could have an affect on it. Let me know how yours works out !

@jordanmcfarland4810 2 месяца назад

One thing I've noticed right away on the iDash is that Boost pressure now goes into the negatives (no more than -4.0 I've seen, usually -1 -2) when decelerating/letting foot off accelerator. Before CCV can, this would go to zero. Question is this acceptable? Bad? Anyone else seeing this?

@Gameplayer70 2 месяца назад

Like you said I think you just got a tight engine. Have you noticed oil usage where you have to add oil between changes? I replaced my oil pan at 500 miles and I’m at about 4200 now and I haven’t noticed any change in level on my dipstick despite a small leak. I just recently got my catch can and got it installed. Great kit, but even with the clamp pliers that was still a total pain. It’s very tight under the firewall, I do not want to do that again lol.

@TakeDeadAim 2 месяца назад

The only thing these will collect on most engines is your money...I blew more than that out my exhaust on my old 4.3 V6 after 100k at start up!lol!

@gasparsperformance9841 2 месяца назад

Is that a N/A motor that runs on 83 octane, a high compression motor that must run on 91/93 octane, or a motor that came from the factory with a turbo or supercharger on it? High compression and engines with power adder usually benefit the most from an oil catch can. A stock low compression n/a motor will see very little blow by unless it has really bad piston rings and/or valve stem seals.

@xtra_9 2 месяца назад

just did the s&b air box, ppe cooler, ppe turbo inlet, stillen scoop and vse catch can last week. love the extra air/turbo noise. with just a little 3,000lbs behind the truck and the worst i saw was ~25 above ambient even pulling 2-3 mile grades in northeast iowa at 25 psi sustained. 35k on the truck and i have never had to add oil between 5k mile changes. don’t anticipate it catching much, but every drop kept out of the dpf equals extends its life. a few hundred bucks is worth it.

@GMguy0013 2 месяца назад

So I just got mine delivered today, went to install it and found a sensor on my heater core line closest to the catch can mounting location. When I put the can in place it literally sits on top of the sensor pushing it down. In your install video I didn't see a sensor there. I reached out to VSE to see what their suggestions are, but if I want to keep it, my best bet is to turn that sensor 90 degrees on the heater core hose but I dont know the risks of doing so.

@DemonWorks 2 месяца назад

There is room for the can to be installed and not touch that connector.

@chrisgoodwin7667 2 месяца назад

Must be nice to actually have one. I pre-ordered and still have not reciprocated mine.

@bryandavies9212 2 месяца назад

Any accumulation collected is better than it coating the cooler. Like most of the PPE improvements, they’ll pay off in the long run.

@user-bf2ov3ws7o 2 месяца назад

Impressive results! It’s always satisfying to see the catch can do its job. We sent you an email, take a look.

@dnutdlux 2 месяца назад

I have the 2020 1500 3.0, and mine has what I believe is the glow plug igniter mounted to the same bolt that the catch can mounts to which has its own bracket that looks like it’s going to be in the way. There’s also a black hose with an in-line sensor in the same location. I contacted VSE and they said it should fit without any modification. Has anyone else had to work around these items?

@levicummins7317 2 месяца назад

So witch one do you think is better PPE or VSE

@gasparsperformance9841 2 месяца назад

The one I’m hoping to release in about a month. Google: 3.0 duramax oil catch can. I made a post about it in the AT4 and Silveradosierra forums.

@Gameplayer70 2 месяца назад

Until PPE releases there’s and it can be tested it’s really hard to say. There’s some differences in design philosophies between the two though. VSE states that they put the can where it is to keep it warm and to keep the hoses short for performance. PPE meanwhile is routing that’s out by the headlight, so it is cooler and the houses are a lot longer. Hard to say which will work better, but a lot of engineering going into both.

@DemonWorks 2 месяца назад

VSE is the only one available right now, o I cannot comment on my opinion at this time.

@gasparsperformance9841 2 месяца назад

@@Gameplayer70 check out the one I created and will be selling in the near future. I engineered my kit to use hardline and AN fittings for longevity. Oil catch can has a dip stick to check fluid level, can screws off to easily remove containments and clean it, along with putting the oil catch can in an easy to access location. Google: 3.0 duramax oil catch can. It should show up on the AT4 and Silveradosierra forum.

@levicummins7317 2 месяца назад

@@DemonWorks right on think you all for the comments I was going to wait for the warranty to end before adding one but I feel like it’s easy to remove if I had too and it would prevent a lot of problems now I am only at 9800 miles on my 2023

@boycestovall8068 2 месяца назад

Why arnt you running it from oil change to oil change instead of 1k miles, then 2k miles? If you run it at 7500 miles off the dash you would see real results. I do agree with the comment above, draining the innercooler to see if any oil made it past the catch can. I just installed mine and changed the oil, so I will run it a full 7500 miles to see what a deleted, LM2 gets.

@Gameplayer70 2 месяца назад

He’s just trying to see results because it’s what people want to know. I just installed mine, and I’ve got about 800 miles to oil change. I’ll drain it then and then leave it alone until next change unless I see something in the site glass. I do 5k oil changes.

@DemonWorks 2 месяца назад

I'm just sharing results. If we look at the info provided from both companies making these available, they both showed an awful lot of oil in their cans. My results are showing nowhere near what any described. At the same time, I have seen people state theirs fills up rather quickly, so a 7500 mile interval would be bad if mine was to fill up quickly. Obviously, this engine yields no oil issues. The stock intercooler was just installed, however the ppe one pulled off did have some oil in it, more than this can did. However, we cannot go by that since this can was installed when the charge air cooler was already installed.

@spencershumilak8383 2 месяца назад

Honestly I think this is another gimmick just like a cold air intake. For the price doesn’t look like it’s worth it. I’d I received one for free to make videos like you o would definitely add it on.

@DemonWorks 2 месяца назад

Thanks for watching !