Walk in freezer with defrost issues 

I’m sure Chris will check every stitch on the hats to make sure it meets his standards !

Dude that Chris impression when you talked about that Orbit gardening wand was HILARIOUS lmao

That clock has a 2021 manufacturing date and died already?

Been wearing Keen boots for the past couple of years and love them. 👍

“Well, Hello There Bill”! I hope all is well with you! Good to see you posting again! Best Regards!

Phenomenal video, thank you so very much, I have to tell you, just between us.... it changed my life! I used to walk with a limp and had carpal tunnel but now after watching this I'm cured 🙏👍👍 may thanks! As a gift to you for the selfless act, if you can help me get this million dollars out of the bank that I just inherited from my great-grandparents from Zimbabwe, I will give you 90% of the money. All I need is your address, mother's maiden name and the last four of your social security number 🍺🍺😁

Nice work Bill. Thank you for the knowledge.

Good to see you Bill great video keep up the good work.

I watch the over time show finally found your channel enjoy it your a cool dude

Hello from the UK. thanks for the new video

Nice job, Bill.

Always enjoy the vids keep em coming

Good job Bill, Looks like you have a snow man in your evaporator coil, or on top of your TXV.

If you mark the termination tab instead of outside dial,you'll have know in about 2min if clock is rotating

I call that tool the “Nut Grabber”

Looks like the evaps are much newer than the off-the-shelf Copeland condensing unit. And a 2-year-old clock that's already dead...

Good one Bill 👍

No need to install timer with housing. Those Grasslin style timers can be installed in the old Paragon timer mount.

9:49 it’s totally cool, makes for a good day.

I'd say that's a crappy clock if it didn't even last 2 years.

I installed Rectorseal surge protectors on my 3 condensers discos. I bought those nut wrenches also. Made the job a lot easier.

Alive!

Hi , and yes I did miss you!

That type of frost you mentioned at the beginning is called hoar frost.

Manufactured less than 2 years ago and likely installed in last year and already failed. Stop putting the 8145s in guys. They are junk. Just go to the 9145. Not much more $.

Called a spanner wrench…

🤘🤘🤘

Well I managed to find it from Canada….

That little wrench is called a spanner wrench. And also here is some useless information. When you come across fluffy ice formation it can be an indication that the coil is running much to cold. The reason for the fluffy ice is that the moisture in the air has no time to condense on the surface of the coil. If the ice is clear it shows that the moisture in the air is condensing out of the air and that the coil is not as cold as the fluffy ice. Clear ice is better for drainage. Isn't that some useless information.

Have you been doing some stand up comedy? That would explain you not posting videos recently. 😂

❤😊 hey there son.

171 thumbs up

👍👍👍

You must be living in Zimbabwe or Canada....they are basically the same place.....😅😅😅😅😅

🇺🇸💪👍❄️ nice