Find a bushing that fits the pin, oversize the hole to a zero tolerance fit so that you have to press the bushing in, freeze the bushing or heat up the hole and drop it in.
That's a easy fix. Go buy pipe from steel yard that fits you pin. When you put a full piace pipe across and install a greese set. I'll pay 300.00 and mod it to work better for a few dollars. Then pay 2000.00 to 3000.00. But that's me. I can weld. Built my ripper tooth for less then 100.00 for subcompact kioti tractor. It works grate with less mess
Yes there are ways to fix it. I understand that. If you follow my channel you can see I’m capable of that. It’s the fact a lot of folks aren’t. So if they are looking into buying this piece and they don’t then maybe go ahead and buy the right thing. I think i was looking at some name brands for around 1600 bucks. I’m already around 900 after buying and upgrading the cylinder and hoses.
Hmm clearly you did watch all the videos. It came with a bigger ram than I put on it. I just put one with more length on it, but ok. (Was not manual) But you would know.
Probably have a few 100 hours on it by now. Getting wallowed out a bit but hey it happens. I think I’ll be looking to get the right one when it wears down to much.
Well in the beginning of the video I stated the people i bought it from put it on. Or welded it on. So it came with it and it was new. I have a few other videos on modding it and now I’m starting to have some luck out of it. But yes a lot of time into it to get a little luck. And not everyone has 2k laying around to just go get one from a dealer. That’s the point of doing the video.
