WiFi / Bluetooth mod for Heltec V3 Meshtastic node. 

I mounted a pigtail to attach a patch antenna (needed to get WiFi through the outer wall of my home) I also soldered a PCB edge SMA connector on instead of the flimsy IFL connector for the antenna. Plenty of ground plane under the white paint on both sides of the PCB to solder all 4 legs. An edge SMA with 1.7mm spacing fits nicely and the center conductor rests perfectly on top of the 0 OHM resistor on the signal line to solder on. would save you another 0.5 dB. I had to unscrew the display and flip it over to have room for the soldering iron, but it fits back on with the SMA connector. Now I also have a neat way to mount the Heltec in an enclosure, simply with the nuts on the SMA connector threads.

Thanks for sharing. I did something similar for a few non-LoRa Heltec dev boards (WiFi 32kit) that I am using for OWM weather data. Was having trouble connecting to WiFi. The pcb antennas are poor at best. I am also using a wire length of about 31mm.

Thanks for the video, I will definitely give this a go

Nice video Paul well explained

Thanks for the video.

What did he replace it with? The video is blurry. Was it just a piece of electrical wire?

Dear god 😅 ehy not get a sma and solder the core wire there and the gnd to grn and use actual 2.4ghz antenna 😅

So, 31mm with or without the soldered bit?

Am I to understand that you are using Bluetooth and Wifi at the same time? I didn't think that was possible. What mode are you using? Client, router, etc.

Thank you, I am considering a similar modification, because Bluetooth is not great either. What wire length did you choose?

Thumbs up