@@Gamer-Wolfie he looks the combination if kirishima and a dragon and optimum prime had a baby. no offense of course its meant to be a funny thing. or maybe its just me
@@Gamer-Wolfie for legal reasons. this is a joke. how to make METAHAMPHETAMINE ingredients: Diluted HCI (dilute muritatic acid) - muriatic obtained in hardware stores add a certain amount of water to the dilute. NaOH - obtained in hardware stores diethyl ether - produced directly from synthesis gas produced from natural gas coal or biomass (engine starting fluid with high ethyl ether content recommended) equipment: glass eyedropper 3 small glass bottles with lids one marked at 1.5oz (labelled as ether) one clear. pryex dish glass quart jar sharp scissors rubber gloves coffee filters measuring cup measuring spoons instructions: 1. make the unmarked small bottle and spray starter fluid in it until it looks half full. then fill the rest of the way with water cap the bottle and shake for 5 minutes let it sit for a minute or two and tap the side to try and separate the clear upper layer then draw off the top (ether) layer with the eyedropper and throw away the lower (water) and cloudy layer. place the ether in the marked container repeat this until you have about 1.5oz. of ether put the cap on it, and put it in the freezer if you can. Rinse the other bottle and let it stand 2. ethyl ether is very pungent. even a small evaporated amount is quite noticeable. 5. pour 1/8 teaspoon of the lye crystals into the bottle of ephedrine and agitate. do this carefully as the mixture will become hot and give off hydrogen gad and/ of steam. H2 gas is explosive and lighter then air avoiding and flames leaving the insoluble free base (1-desoxyephedrine) again. why do we do this? so that we can get rid of any water-soluble impurities. for 3 oz bottles this should take only 3 repetitions of so. 6. fill the bottle from step 5 up the rest of the way with ethyl ether. cap the bottle and agitate for about 8 minutes. it is very important to expose every molecule of the free-base to ether for long as possible. this will cause the free base to dissolve into the ether (it-is-soluble in ether) 3. let the mixture settle. there will be middle layer that is very thick. Tap the side of the bottle to get this layer as thin as possible. This is why this bottle should be clear. 8. remove the top (ether) layer with the eyedropper being careful not to get any middle layer in it. Place the removed ether layer into a third bottle. 4. Add to the third bottle enough water to fill it half-way and about 5 drops of muriatic acid cap it. Shake the bottle for 2 minutes. When settles remove the top layer and throw it away. The free base has now been bonded to the HCI again forming a water soluble salt. This time we're getting rid of ether-soluble impurities. Make sure to get rid of all the ether before going to step 111 10. if there is anything left from step 3 repeat the procedure with it. and for finale 5. Evaporate the solution in the Pyrex dish on low heat. You can do this on the stove or nuke it in the microwave (be careful of splashing) but i have found that if you leave it on top of hot-water heater (like the one that supplies hot water to your house