Winpak Configuration for Fire Panel Integration

Подписаться 5 тыс.

Просмотров 1,7 тыс.

50% 1

यह वीडियो फायर पैनल के साथ विनपैक कॉन्फ़िगरेशन के बारे में आपका मार्गदर्शन करता है।
This video guide you about Winpak configuration with fire panel.
Low Voltage, #Winpak , # Honeywell Access control software, # Access control # Fire integration,

Опубликовано:

5 окт 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 10

@lakshman9229 2 года назад

How to assign card bit settings in panel configuration

@lakshman9229 Год назад

How to configure door buzzer time delay activation

@lakshman9229 Год назад

Sir out 2 which port you are used

@lakshman9229 2 года назад

Sir card data not reading reader

@NaveenKumarDurairajan 2 года назад

Sir, if I have 10 No's controller using by 2 floors, each floors having 5 controller and also seprate fire alarm panel at each floors, should I create comment file for both floor seprate (open all doors and close all doors?)

@Lowvoltage 2 года назад

Please share your company name and location

@manikantag.5412 2 года назад

Sir please tell me connections for fire intigration in acess control panel and as well as address module

@Lowvoltage 2 года назад

In this DCMO module, connect pin 1 as loop OUT - ; pin 2 as loop OUT + ; pin 3 as loop IN - ; pin 4 as loop IN + ; Connect pin 8 & 11 of this module to the fire input port on the access control panel.

@Lowvoltage 2 года назад

Please share your company name and location