Thank you for the reply. Its that time of the year to start using our permanent LED setups. Im just wanting to use them year eound with architectural accent lighting with the soft white leds on my SK-6812 strips.
Will these pot lights work with other brand lights or are they proprietary to the brand of strings you sell? I have x connect based pixels and would like to use these if possible.
Hey, ya you can cut the plug off and hard wire it to your system if you want. If your lights are WS2811 these won't work with that. These are SK6812 RGBW3000K not WS2811 RGB.
Ha ok ya that's what I figured. I have been playing around with ledfx, you can run it from your computer and it will take control of the wled controller and move the lights to the music. You can also install it on a seperate esp controller and run it from your phone with the ledfx app, which is what I plan on doing next. I'll let ya know how it goes. thx
This is possible with the right user mod uploaded to WLED and using the extra GPIO ports in the controller. There is lots of videos with people using the staircase mod with WLED and motion sensors to illuminate staircases. I think this same logic would work outside if you wanted lights to come on as you walk past a specific area. I have not done this yet, but I will start looking into it. Thanks!
@@showhomelighting5840 it is good idea.... It is similar to what you explain. How many Sensors I can bring to GPIO on 1 esp32? ( because I will like to have 4 sectors each to have 2 Sensors to see me from where I came and to start the light from that direction) Or it will by more easy to coonec each sector (from the 4) separate the 2 Sensors... But I am not sure If it is posibile to connect 4 esp32 în a whay so all the sectors to work later în just 1 big sector and play for exemple on Christmas sone presets like evreting it is just 1 big sector
@@showhomelighting5840 thank you very much if you try to test this ... I think it would be the most helpful if you try to do this with as long address sectors as possible because what I want will be sector 1 = 200( addressable zones, 1 zone = 3 led of Ws2811 because the led streep is 60 led/m per 3 address, so 1 m =20 addressable zones), 2 = 174, 3 = 196, 4 = 227. From how many meters will do I have to make an injection point for the data signals to not be lost?