Wolf Inlay 

Thank you, cant wait to try it out.

Absolutely amazing tutorial- definitely pushed me into buying this software!

Love this tutorial! New sub for you 😊

finally a great video thanks so much

Thank you sir

Great stuff

Very nice Video. Are This depth also Working with 10 and 20 degree Bits?

Hi Chad. Thank you for a comprehensive yet easy to follow instructional video. One thing that puzzles me - do you not need to reduce the size of the male part so that it fits snugly into the female?

Great info. Thanks! Would be interested to see your press. Also, have you used a vacuum bag?

if i want to cheat the machine using a 5 degrees tapered ball nose end mill so i can get more detail how i can turn this too into a v-carv tool

Do you use the same parameters regardless of bit angle? Obviously less detail vectors, but does same number add up if 90 or 60 degree bits were used?

Chad I have watched this wolf video and I have not been able to figure the start but I see you use a ball endmill with a 6.2 taper and you call it a vbit. so you do not use the rad but that is not going to give a true dia. my males always come small i had to change my start depth to .05 and my finish depth of .150 and it fits pretty close. so where am i going wrong. and I would love to see your pneumatic press Marcel deman

With male .05 being max depth (inside gap between pocket and male), is that enough gap to make it have a hollow sound when tapping on cutting block? Others say it should be closer to .02 when it comes to cutting blocks so no hollow sound when tapping. Non-cutting block inlays are good at .05. Your boards look real clean but have never seen any of your videos showing tapping on the inlay and am curious. Thank you!

Hi i have a doubt, you are doing both carving on the same side so if i want to make it fit perfectly one of the vectors should backwards right ?

Very Nice I am just starting to learn the Inlays How deep should i be going on a Engrain Cutting board I use Carveco

When I do the inlay, the pieces dont fit. I'm using Amana 45780.

Can you share a picture with me of what your press looks like please?

What bit do you use

Can you share how youafe your press?

I’m doing the female part right now and I notice the bit is coming up and out at the edges is that normal ?