Xerox WC 5655 Main Motor Problem | PART I 

Check the fuser gear bushing.

@@macor285 can you explain exactly where is that

@@aaagaming2926 Identify first where is the location of the noise coming from. If it is from drum or fuser? If from the fuser, the fuser gear needs to be check. When you remove the fuser unit, you can see the gear inside the machine. Replacing the fuser gear is a little bit complicated. If the noise coming from drum unit, check the registration clutch or clean the drum unit. Good luck.

@@macor285 it looks like it is coming from somewhere near bypass tray. It's not from drum

@@aaagaming2926 run diagnostic routines.

Yes, you can repair.

What is the error?

English only sir.

@@macor285 After being xeroxed from my Xerox 5225 machine, the writing is going up with a little rubbing by hand. I changed the drums, but it didn't work out. How to fix it.

Just check on the left cover remove the clutch assembly. The small rubber is missing. Just replace it with a piece of paper.

@@macor285 please give give video how do it

@@xerorprint3367 I don't have the video. You can check from the service manual. Download: yadi.sk/d/QiLcUXEYuA7yP see page 784. Good luck.

What is your photocopier? No power? What is the problem?

@@macor285 5655 . Yes no power but I found asmoll lamb in back bord is working

@@abdo584 if you familiar with the board where the utp cable is connected at the back. open it then you can see software module with yellow square like IC. remove it the clean the slot and the software module with pencil eraser.