Z-Leveling for Delta Printers with Repetier-Firmware 

Any idea how to hook up the limit switch for this type of bed leveling on a MKS Base 1.4 board?

Hey, great video, is there a automated method to correct the endstops without the rods eg with test points near the towers?

yes, can you upload your firmware you used, my printer keeps trying to read off the build plate during the bed height measurements and causes the hot end tip to drive into the bed and make the belts slip and hard crash.

Love the video! I have a question though. When I use Height Map my starting point is X -110, Y - 60. When I run my G33 command it starts at X -110, Y 60. How do I get my G33 to run the same path as my Height Map, or does it even matter what path my G33 starts?

How to calibrate dual nozzle for Z height??

How to do this with the Cartesian printer?

How long is the rod you used to get the axis equal height?

My configuration.h is the same as yours except dimensions differences including rods length, radius etc, other than that the corrections and leveling are set to the same as yours, but g29 measure only 3 points like other users and g32 s2 measure a grid, what's wrong with my firmware?

better now! the bed heigt map on the tool tabs in repetier is grey and unusable... Do you know why??

followed all the steps up to running the first bed leveling routine G32 S2. The printer tested some weird points, tested the centre twice and then a point slightly off centre. After this is did not home again and spat back NaN for all 3 values in the host, and told me autoleveling was disabled. After that all my steppers refuse to work at all. They will turn on for about half a second when the machine is reset or turned on but nothing after that. Printer will also hang if told to home axis. Any advice will be appreciated.

i have no tool tab section on my software or nothing that says bed heat map, i downloaded your version and i dont even see it there and the new update dont have this feature whats going on ?

the m99 x0, m99 y0, m99 z0, and g132 s1 commands dont do anything for me! please help ive been having this problem for some time now.

Having problem with my delta printer!! Everything is ok until the g29 command. It wants to go to these coordinates X7562 and Y 6894 ??? Does anyone had the same problem ?? What should i do ??

thanks for your video! but on my "show in log" I've never seen "zCorr: ..." and all the operation seems do nothing... (the Zmin and Z max stay the more or less the same)

You say g29 measures 7x7 points. Mine only measures 3 points defined in EEPROM, and the log never shows any correction information. What am I doing wrong? Repetier 0.92.9. I have also tried g33, but it says it is an unknown command.

hello, when i enter G29, it only goes to 3 point(different from you) and so how to add the correction factor in it ?

what kind of delta is this?

Once this is done, is it permanent? Or does this have to be done every time you print?

my 3d printer wont connect to repetier