ZETOR 4712 BRAKE REPAIR (part 4) FINISH

Подписаться 1,3 тыс.

Просмотров 16 тыс.

50% 1

The video shows the assembly of the reducer and the adjustment of the brakes and testing. #zetor #brake #brakerepair #brakeservice #brakesystem #brakeshoe #mehanic #diy #diycrafts #restore #remove #tractorvideo #video #test #settings #setting Video prikazuje montažo reduktorja in nastavitev zavor in testiranje. Das Video zeigt die Montage des Reduzierers und die Einstellung der Bremsen und Tests.

Опубликовано:

20 сен 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 10

@colmanlong1032 8 месяцев назад

Love your videos,great information.

@joccohr7959 10 месяцев назад

Great job, I own a Zetor 4911, it's 40 years old and it should do the same. How much do you think it would cost me?

@milantasic6669 5 месяцев назад

Hey brother really6 nice work. my Zetor is 3511 S and is exactly looks the same like this one even the size of wheels and all completely, probably the only difference is smaller engine less HP. Best regards from Serbia !

@MadMaxTheProducer 5 месяцев назад

yes i think you are right but be careful. thanks for watching and nicely written, and best regards

@DharamjeetPandey-uz1rb 7 месяцев назад

क्या इस प्रकार का जेटर ट्रैक्टर नया बनता है या नहीं

@milanjeremic3103 Год назад

Hello, can you help me, I have done the brakes in my Zetor, everything is new, but the drum is hot, the belts are as loose as possible and when installing the drum, it went in without any problems and did not worry about the brake pads, what could be the problem. Thanks in advance. greeting

@MadMaxTheProducer Год назад

If the drum heats up despite replacing all worn brake parts, the problem must be elsewhere. usually the drum heats up if any brake lining slides against the surface of the drum. This could happen if the handbrake strap is tightened too much. Before installing the handbrake belt, we stretch it a little so that it does not block... but the problem could also be in the master brake cylinders. they are installed under the brake pedal. could it be that they are locked up and not letting the brake shoes release? I hope the advice was helpful. Good luck

@milanjeremic3103 Год назад

@@MadMaxTheProducer All the cylinders are new, both in the wheels and on the pedals and the belts are completely loosened, the problem is somewhere in the main brakes, I just don't understand what, during installation the drum sat down easily, it didn't get stuck on the tires, it turned without any resistance or rubbing against the tires, after letting the air out of brakes, there was a problem with heating the drums, which I can't solve. Thanks in advance.

@MadMaxTheProducer Год назад

@@milanjeremic3103 which tractor do you have?

@milanjeremic3103 Год назад

@@MadMaxTheProducer Ursus c4011