7 лет назад

In this video i show you how you can machine you own "tap drivers" as I like to call them. This is a simple split bushing that is used ...

3 года назад

I put the @Flex Machine Tools GHM-60 to the test and max out it's capabilities using a @osgtool 2"-4-1/2 tap. I have a couple ...

2 года назад

I get our new FlexArm for the new shop unboxed and setup. This is the FlexArm model RNR-20 that has a pneumatic motor and ...

6 лет назад

This week we get to some machining on the Kearns horizontal boring mill, doing some deep hole drilling and tapping. I also share ...

Месяц назад

This week we'll get the last of the steel plates finished up. In this video we'll use the Flex cnc to machine the 32 holes required in ...

11 месяцев назад

Looking to make your social media presence really stand out? Want to get more followers on your social media accounts?

7 лет назад

This week I'll start off with a couple viewer gift items I received. I also rant a little about customer service. At work I have been ...

3 года назад

Video Credits : ( IG ) @abom79 Video Source : ( IG ) world_of_engineering Please follow on Instagram : @abom79 ...

7 лет назад

Go to 9 minute mark for the machine work footage. This week I have some footage from work. First job is a Heli-coil thread repair ...

19 часов назад

We were invited up by @GFIICuttingTools to take a tour of their cutting tool factory located in Seneca, South Carolina. There we ...

5 лет назад

Continuation of short video clips of different machining jobs. Paypal Donation: ...

8 месяцев назад

We're back in the K&T mill and will now get the dynamic jaw body drilled and tapped for the bolt on jaws. I use our extended reach ...

7 лет назад

First of a short series of videos about machining a 9 1/2" gearbox shaft. This shaft is very similar to my past Heavy Metal Machining ...

Месяц назад

After experiencing issues with rigid tapping I wanted to test out the use of the Techniks MicroFloat tapping holder which gives the ...

Год назад

This was a machining job I did to help out the welding shop. 4"x2" heavy wall mechanical tubing that needed machining for a 2" ...

Год назад

This week's Saturday Night Special includes a few small machining jobs that I worked on over a couple weeks. These quick jobs ...

5 лет назад

One great chapter comes to an end, and a new one begins! Paypal Donation: ...