Can I do this with the power on going to the breaker box?My breaker box does not have a way to completely shut power off, It's an old breaker panel from about 1967.It doesn't have an off switch an off lever.Or anything to turn the power completely off to the whole panel. I. Think the panel is made by pacific, Don't know if they're still in business
If I put the new box and outlet right next to my breaker box ,Which is located outside on the back of my house, Then the cord on my window AC unit would not reach it. I would have to use an extension cord probably more than fifty feet , but less than a hundred feet. Run the extension cord along the back of my house. Until it gets to the bedroom where the new A. C unit is. and drill a hole through my block wall and run the extension cord end to plug the ac unit into.
I’m axing everybody around can you put a 2011 jeep liberty sport engine 3.7 into a 2011 Jeep liberty 3.7 or can you put it engine from a jeep liberty 2008 and put it into a 2011 Jeep libertyor you could put a 2009 or a 2010 or 2012 jeep liberty 2011
Dodge 4.7 engine 16 tooth or 32 tooth tone ring, how to tell the difference. Dodge made a 2002 4.7 engine, and they made a 2002 and a half 4.7 engine. check the PCM. the 16 tooth tone wheel is used with the early JTEC controller and the 32 tooth tone wheel with NGC controller, two different levels of PCMs and different connectors and harnesses. 3 plugs on the PCM are an indication of a 16 tooth tone wheel, 4 plugs indicate a 32 tooth tone wheel. the 16 tooth tone wheel is used with the early JTEC controller and the NGC engines 2003-2007, (4-PLUG PCM) use a 32-tooth tone ring. the difference between these two vehicles, is the ECU on the 2002 4.7 has 3 connections on the box and the 2002 and half 4.7 has 4 connections. REMOVE the crank sensor under the vehicle using a 13mil. and look inside the empty sensor receptacle hole at the Crankshaft Reluctor Ring Teeth Tone. a 16 tooth on tone ring has WIDER teeth and wider spaces between teeth. the 32 has SMALL teeth. CONFIRMATION: 16 is a 3 plug with external TCM and a 32 is 4 plug, the intake is smooth on s 16 tooth vs the rough 32. note: PCM (Powertrain Control Module), ECU (Engine Control Unit) and ECM (Engine Control Module) terms are sometimes used interchangeably.
I done the motor swap but didn’t realize my original motor was ngc and the donor is jtec but it runs completely normal wit the ngc tone wheel and the jtec reluctor but won’t rev past 2400 and act like the crank sensor is bad I also have the proper reluctor ordered through airram
I suppose it would be the opposite if I wanted to put a 2004 into a 2008? Meaning put all the 2008 ring and gears into my 2004. Besides all the other plugs and intake etc.
Perhaps you could have done a better job explaining where you were putting back the wires back onto the relay. Not all viewers are experienced enough to know what goes where and thus the reason why they view your video Thanks
so... what about the tooth count difference on the cam gear? are you guys pulling the rivets and putting the older sprocket on to the "new" reluctor wheel or are you doing an entire timing kit. because the chain does not go onto the sprocket of the new one
Dodge 4.7 engine 16 tooth or 32 tooth tone ring, how to tell the difference. Dodge made a 2002 4.7 engine, and they made a 2002 and a half 4.7 engine. check the PCM. the 16 tooth tone wheel is used with the early JTEC controller and the 32 tooth tone wheel with NGC controller, two different levels of PCMs and different connectors and harnesses. 3 plugs on the PCM are an indication of a 16 tooth tone wheel, 4 plugs indicate a 32 tooth tone wheel. the 16 tooth tone wheel is used with the early JTEC controller and the NGC engines 2003-2007, (4-PLUG PCM) use a 32-tooth tone ring. the difference between these two vehicles, is the ECU on the 2002 4.7 has 3 connections on the box and the 2002 and half 4.7 has 4 connections. REMOVE the crank sensor under the vehicle using a 13mil. and look inside the empty sensor receptacle hole at the Crankshaft Reluctor Ring Teeth Tone. a 16 tooth on tone ring has WIDER teeth and wider spaces between teeth. the 32 has SMALL teeth. CONFIRMATION: 16 is a 3 plug with external TCM and a 32 is 4 plug, the intake is smooth on s 16 tooth vs the rough 32. note: PCM (Powertrain Control Module), ECU (Engine Control Unit) and ECM (Engine Control Module) terms are sometimes used interchangeably.
Very informative, great video. Will this work for me? I swapped 2001 3.7 from Jeep liberty into 2004 Durango 3.7. However, vehicle will not start. Can I use this kit to correct issue?
I understand intermittent pilot conversion kit can save the fuel costs associated with continuous pilot. Are the kits costly and complicated to install
Didn't really show or explain anything just showed the boring bar in use but no instruction on setup or how much was taken off. Not a very good "How to" video.